Publicité
Les langues disponibles
Les langues disponibles
LENGTH ADJUSTMENT:
To adjust the length of the heelpieces, the two screws must be loosened (5)
with the provided T25 tool.
Slide the heelpiece to desired length and then fasten the adjustment screws
tightly (5).
It is possible to place the screwdriver vertically between the heel
piece and the ski boot to reach the adjusting screw.
GAP BETWEEN HEELPIECE AND BOOT
A 4mm gap must be respected between the boot insert and the heelpiece
housing.
This 4mm gap is set with the spacer provided with the bindings.
TOE PIECE
The WEPA bindings are equipped with a locking system on each toe piece.
This locker can be in two positions: either WALK (locked) or SKI (Unlocked).
When the toe piece is stepped-into, it is automatically in ski mode.
CARRYING AND STORAGE
During all the time of carrying, putting off skins, relaxing time on summit,
bindings must always be in WALK mode in order to limit ice storage under the
toe piece. Otherwise, it could be more difficult to step in.
STORAGE BETWEEN TWO SEASONS
Bindings must be dry, clean and with grease. Close the toe lever (3) and
decrease release value of the heel piece.
User Manual
Using Instructions
8 |
P a g e
Publicité
