Description Of The Hood; Control - Elica EST630SS Guide D'utilisation, D'entretien Et D'installation

Secure the bottom of the duct with 2 assembly screws
provided.
Install the grease filters and turn power on at service
panel. Check operation of the hood.
If range hood does not operate:
Check that the circuit breaker is not tripped or the house
fuse blown.
Disconnect power supply. Check that wiring is correct.
To get the most efficient use from your new range hood, read
the "Maintenance" section.
Keep your Installation Instructions and Use and Care Guide
close to range hood for easy reference.

Description of the hood

1
2
3
4
1. Blower and LED lamp controls
2. LED lamps
3. Grease filter handle
6
5
4. Grease filters
5. Perimetric cover
6. Duct covers

Control

Description of control panel
1 2 3
1.
Button ON/OFF motor (stand by)
2.
Button for low speed (suction power) selection
When flashing, it indicates that you must wash the grease filter.
3.
Button for medium speed (suction power) selection
4.
Button for high speed (suction power) selection.
5.
Button for intensive speed (suction power) selection
it lasts 5 minutes then it returns to medium speed
(suction power).
6. Button ON/OFF lighting
Press briefly to switch on or off the lighting of the hood.
Press and hold to adjust the intensity of the light.
Press again to turn the lamps off.
7.
Automatic operation (sensor), connection with Golden
Induction Cooktop® and Diamond Cooktop®.
Initial Calibration
The sensor in the hood provides an activation time, when you
plug your appliance to the power for the first time.
This activation will take 5 minutes. After this process, you
can set your hood to automatically connect with an Elica's
cooktop, or make the Manual settings to calibrate the sensor
to work without connectivity.
Automatic operation (sensor), connection with Golden
Induction Cooktop® and Diamond Cooktop®.
Attention!: The proper operation of the hood will depend on
the 'Setting of parameters for Automatic Operation'
(see dedicated section)
To connect the hood and hob, plug both appliances to the
power at the same time.
Once you plug the range hood to the power, it will start
the calibration process. The icon
minutes.
Press the button
. (the LEDs light up in white) to
indicate that the hood can automatically operate with the
Elica cooktop; thus, hood operation will also depend on
use of the Elica cooktop.
NOTE: Automatic operation with the cooktop is possible only
with specific cooking cooktops; for further details, please
contact the authorised dealer or technical assistance centre.
Automatic operation with any cooktop (sensor)
Once you plug the range hood to the power, it will start
the calibration process. The icon
minutes.
Once the icon has finished the calibration process,
press the button (the central LED lights up in white)
The hood will switch on at the most suitable speed based
on the cooking fumes detected by the sensor on the hood.
Setting of parameters for Automatic Operation
NOTE: All calibration, selection, setting and logical connection
operations described below can be performed with the hood
off (OFF).
The adjustment of parameters is regularly done automatically
every time the hood is reconnected to the mains (e.g. with the
first installation or after a blackout) or manually.
4 5 6
will start flashing for 5
will start flashing for 5
7
9