Hotpoint Ariston HLB 9.5S AT/HA Mode D'emploi page 34

Servicing the grease filter (A)
GB
If washed in a dishwasher, the metal filter may change
colour, but this does not affect its performance.
Antigrease filter maintenance (Dual filter drawing)
The antigrease filter absorbs the grease particles that form
while cooking. This filter performs better than standard filters
as it combines a filter entirely made of steel with a filter with
various layers of metallic mesh. It must be cleaned at least
once a month with non-aggressive detergents by hand or in
the dishwasher at low temperature and with a short cycle.
Pull the spring release handle to dismantle the grease filter.
Servicing the charcoal filter (B)
The charcoal filter retains unpleasant cooking odours.
The filter saturates after a variable time, depending on the
type of cooking and how often the grease filter is cleaned.
The cartridge must be replaced at least once every twenty
months.
This filter can NOT be washed or regenerated
B
34
The grease filter retains the
particles of grease produced
during cooking; it must be
cleaned at least once a month
w i t h a n o n - a g g r e s s i v e
detergent, either by hand or
A
with a low temperature, short
dishwasher cycle.
To extract the grease filter,
pull the spring loaded handle.
Disassembly: Remove the
activated-carbon filter by
pressing the two front levers
B
which secure it to the hood.
A s s e m b l y : S e c u r e t h e
activated-carbon filter first in
the back using the hood's
metal tabs and then in the
front by pressing the two
levers.
High Performance odour filter maintenance. (Drawing
cylindrical filter + aesthetic box
The activated carbon filter absorbs unpleasant cooking
odours. To obtain an excellent ventilation performance, the
filter is bigger than standard filters and is installed inside the
box placed above the hood. Carbon filter saturation takes
place after a variable period of use, depending on the type
of cooker and on the frequency of cleaning the grease filter.
The cartridge needs replacing at least every five years. This
filter CAN NOT be washed or regenerated.
*
To carry out this operation, the use of gloves and a ladder
is advised.
*
Only available in certain models
*
Disassembly: Unfasten the
front panel of the box housing
the filter from the top, remove
it completely from the box and
access the cylindrical filter.
Remove the filter securing
screw with a suitable tool and
pull it out with both hands. To
carry out this operation, the
use of gloves and a ladder is
advised.
Assembly: Insert the filter
inside the box paying attention
to its orientation (the hollow
part of the filer must face the
hood).
Secure the filter with the
fastening screw provided.
Hook the front panel of the
box to the tabs at the bottom
first and then push it in the
upper part of the panel until
the pivots wedge in..