Jydepejsen Sigma Mode D'emploi page 29

1. Dismantling the frame. Use an 8mm wrench.
2. Remove the 4 screws holding the frame.
3. Raise the stove and pull out the box.
4. Install the convection box in the non-flammable wall.
5. Place the stove on the rearmost feet and push it in. Make sure you do not push the stove when the front feet are
placed on the convection box bottom because the rubber can be destroyed.
6. Adjust the front feet by raising the front of the stove. If necessary, the rearmost feet can be adjusted inside the
stove. To do this you will have to remove the vermiculite insulation and then use a 4 mm Allen key to screw the
feet in.
7. Install the frame again.