Publicité
Les langues disponibles
Les langues disponibles
Installation Instructions - G12 LED
INSTALLATION
Identify what type of unit is being installed. This will aid you
through the remaining of the installation instructions. Refer
to each section for each specific type of unit. There are
two styles of units (flat and shallow) as described by their
depth of protrusion from the mounting surface (see figures
below). Begin by removing lens assembly using a Torx T20
screwdriver for screws with center pin. (Screwdriver sold
separately, Cooper Lighting Solutions catalog number
VRSD or 1/4" bit VRSB).
Flat Unit Installation
1.
Remove lens, using a TORX T20 center pin reject
screwdriver.
2.
Select the correct type fasteners to use for the
mounting surface, 1/4" nominal diameter (not supplied).
3.
Center mounting plate on flat smooth ceiling or wall
over junction box. Use mounting plate as a template to
layout fastener locations. (Figure 4.)
4.
Connect fixture wires to the proper supply wires and
place in junction box. Minimum 90 deg supply wire
required. Ground fixture with wire provided.
Do not touch LEDs on fixture, care must be taken to not
come in contact with LED board(s) or connector(s) during
fixture installation.
12.31 in
5.26 in
Figure 1.
Flat Unit
2
COOPER LIGHTING SOLUTIONS
12.31 in
IB519020EN Installation instructions
12.03 in
6.72 in
Figure 2.
Shallow Unit
Gasket
Back Plate
Lens
Figure 3.
Flat Unit Installation
Gasket
Square
Pattern of
Mounting
Holes
Back
Plate
Clearance Hole for 1/4" Bolt
Figure 4.
Flat Unit Installation
12.38 in
Wall
Junction
Box
Publicité
