Publicité
Les langues disponibles
Les langues disponibles
5.
Align fixture without lens to four mount holes. Tighten
all four mounting fasteners sufficiently to compress
housing into gasket. If using the eyelid option, make
sure the eyelid is also in the "up" position.
N
ote:
If mounting surface is uneven or rough, it will
be necessary to caulk around fixture to provide
water tight seal.
6.
Replace the lens by aligning (4) lens screws and (4)
mounting plate slots. On the plate, they should be
located at the "3, 6, 9 and 12 O'clock" positions. Do
not over-torque the screws during installation of lens.
Shallow Cast Unit Installation
1.
Remove lens, using a TORX T20 center pin reject
screwdriver.
2.
Remove back plate using Philips screwdriver.
3.
Select the correct type fasteners to use for the
mounting surface, 1/4" nominal diameter (not supplied).
4.
Center cast housing on flat smooth ceiling or wall over
junction box. Use cast housing as a template to layout
fastener locations. (Figure 6.)
5.
Remove the four donut gaskets from the supplied
square gasket set. Peel the backing from each of the
four donut gaskets and apply them to the back side of
the cast housing at each of the four mounting holes
(gasket has adhesive on one side). Use the remaining
gasket square to seal cast housing to J-Box. (Figure 7 .)
6.
Connect fixture wires to the proper supply wires and
place in junction box. Minimum 90 deg. supply wire
required. Ground fixture with wire provided.
Do not touch LEDs on fixture, care must be taken to not
come in contact with LED board(s) or connector(s) during
fixture installation.
7 .
Align fixture without lens to four mount holes. Tighten
all four mounting fasteners sufficiently to compress
cast housing into gasket. If using the eyelid option,
make sure the eyelid is also in the "up" position.
If mounting surface is uneven or rough, it will
N
ote:
be necessary to caulk around fixture to provide
water tight seal.
8.
Replace the back plate which was removed in step 2.
Replace the lens by aligning (4) lens screws and (4)
mounting plate slots. On the plate, they should be
located at the "3, 6, 9 and 12 O'clock" positions. Do
not over-torque screws during installation of lens.
Maintenance: Verify that the power is OFF.
Lens panel should be cleaned on a regular schedule (6 to 12
month intervals based on local conditions).
Shallow Casting
Lens
Figure 5.
Shallow Cast Unit Installation
Mounting Hole
Figure 6.
Shallow Cast Unit Installation
Gasket (4) Places
Gasket (As
Supplied)
Figure 7.
Shallow Cast Gasket Location
COOPER LIGHTING SOLUTIONS
Installation Instructions - G12 LED
Shallow Casting
Back Plate
IB519020EN
Installation instructions
Wall
Junction
Box
Gasket
3
Publicité
