Safety-Related Information On Decommissioning And Dismantling; Liability And Disclaimer - Elektror S-HP ATEX Instructions De Service / Instruction De Montage

Operating and assembly instructions S-HP ATEX
ship with Elektror and are trained in the repair of our ATEX
blowers. Our service partners rigorously comply with the
ATEX regulations applicable throughout the EU, but also the
intrinsic manufacturer-specifi c guidelines that we apply to
our ATEX products to increase safety.
Deviations from one of the procedures intended to maintain
safety, health protection or explosion protection may lead to
loss of the warranty and the assumption of liability on the part
of Elektror.
6 SAFETY-RELATED INFORMATION ON
DECOMMISSIONING AND
DISMANTLING
The disconnection of all electrical connections and any other
electrical work in connection with decommissioning must
only be carried out by a qualifi ed electrician.
The device should be dismantled only when all rotating parts
have come to a standstill and cannot be restarted.
The guidelines set out in 2.1 Transport and Handling must be
observed when dismantling and removing it.
Treat the device as industrial waste when disposing of it.
The device parts are made of recyclable material, such as
aluminium, (stainless) steel, copper and plastic. However,
there are components that need special treatment (e.g. fre-
quency converters). The statutory national and local disposal
and recycling regulations must be observed.

7 LIABILITY AND DISCLAIMER

The machine operator shall bear the responsibility for the
correct use of the device.
Elektror shall not accept any liability for any use of its prod-
ucts and components which is contrary to their intended use.
This shall also apply in particular to use in special applica-
tions and under operating conditions that have not been spe-
cifi cally agreed with Elektror.
Elektror shall accept no liability for any modifi cations or al-
terations to the device or accessories supplied.
Likewise, Elektror shall not be liable for improper, delayed,
neglected maintenance. Neither shall it be liable for any
cleaning and repair work not carried out by qualifi ed Elektror
specialists, nor for the possible consequences.
www.elektror.com
EN
23