Télécharger Imprimer la page

Velleman DVM205AM Mode D'emploi page 5

Masquer les pouces Voir aussi pour DVM205AM:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

c) Relative Button (fig. p.2 #4)
The relative measurement feature allows you to make measurements relative to a stored reference value. A
reference voltage, current etc. can be stored and measurements made in comparison to that value. The displayed
value is the difference between the reference value and the measured value.
1. Perform any measurement as described in the operating instructions.
2. Press the REL(ative) button to store the reading in the display and the REL indication will appear on the display.
3. The display will now indicate the difference between the stored value and the measured value.
4. Press the REL button to switch the relative function off and return to normal operation.
d) Data Hold / Backlight Button (fig. p.2 #5)
The data hold function allows the meter to "freeze" a measurement for later reference.
1. Press the DATA HOLD button to freeze the reading on the display. The HOLD indication will be displayed.
2. Press the DATA HOLD button again to return to normal operation.
Press the button for more than 2 seconds to switch the display backlight on or off.
e) Mode Button (fig. p.2 #6)
Use the Mode button to select AC/DC voltage, AC/DC current, resistance, diode, continuity or capacitance check.
f) °C/°F Button (fig. p.2 #7)
The °C/°F button is used to switch between °C and °F when measuring temperature.
The default temperature unit is °C.
6. Operating Instructions
1. Set the selection switch to the OFF position when the device is not being used. In order to prevent battery
leakage, the device automatically powers down when it has not been used for approx. 15 minutes.
2. If "OL" appears in the display during a measurement, the value exceeds the selected range. Select a higher range.
3. When a low voltage range is selected, the display may show a varying reading although the leads are not
connected to a device or circuit. This is normal and is caused by the high input sensitivity. The reading will
stabilize and give a proper measurement when connected to a circuit.
a) Voltage Measurements
1. Plug the black test lead in COM (fig. p.1 #10) and the red test lead in the + connector (#11).
2. Set the selection switch (#8) to the Vdc/ac position and press MODE (#6) to select AC or DC voltage.
3. Put the leads over the load to be measured and read the measured value from the LCD.
NOTE: Pressing the Hz/% button will cause the display to switch to frequency or duty cycle.
b) Current Measurements
CAUTION: Do not make current measurements on the 10A scale for longer than 30 seconds every 15 minutes.
Exceeding 30 seconds may cause damage to the meter and/or the test leads.
1. Plug the black test lead in the COM jack (#10) and the red test lead in the + jack (11) for max. 400mA
measurements, or in the 10A jack (#9) for max. 10A measurements.
2. Set the selection switch (#2) to the desired current measuring position (µ A, mA or A).
3. Press MODE (#6) to select AC or DC current.
4. Put the leads in series with the load under test and read the measured value from the LCD.
NOTE: Pressing the Hz/% button will cause the display to switch to frequency or duty cycle.
DVM205AM
- 5 -
VELLEMAN

Publicité

loading