Honeywell HCE80 Mode D'emploi page 19

Commissiong and binding the evohome
controller
If you want to control the room temperature with
the evohome controller (that has to be located
in this room), press YES. Otherwise press NO
and connect a sensor – either a room thermostat
(DTS92/T87RF) or a room setpoint generator/
sensor (HCW82/HCF82).
Binding a room thermostat (DTS92)
Keep the
1
long to set the room thermostat to standby.
Keep the ▲ and ▼ button pressed
2
simultaneously for 3 seconds.
INst should be displayed.
Press the ▼ button.
3
COnt should be displayed.
Press the ▲ button three times.
4
CLr should be displayed.
Press the
5
existing connecting data.
Press the ▲ button.
6
COnt should be displayed.
Press the
7
send the connecting signal to
the evohome controller.
You should receive a SUCCESS
8
message at the evohome controller
(if not, go back and bind again).
1
2 SECONDS
HCE80(R) / HCC80(R) Mounting and operation
button pressed 2 seconds
button once to delete
button once to
2
3 SECONDS
Binding a room setpoint generator/
sensor (HCW82 or HCF82)
Briefly press the bind button in the bottom
1
right-hand corner. The red LED flashes.
You should receive a SUCCESS
2
message at the evohome controller
(if not, go back and bind again).
1
Connecting the temperature selector (T87RF)
Keep the left-hand field below the display
1
pressed for approx. 10 seconds.
bo flashes.
Turn the upper part clockwise
2
until Hc is displayed.
Press the left-hand field below the display
3
briefly.
flashes several times.
You should receive a SUCCESS message
4
at the evohome operating device
(if not, go back and bind again)
10 SECONDS
15