Installing The Underfloor Heating Controller - Honeywell HCE80 Mode D'emploi

Installing the underfloor heating controller

The underfloor heating controller can be installed within or outside the distributor box.
4 4.2-mm holes for installation are located on the underfloor heating controller.
Wall installation
Mark, drill and insert plugs into fastening holes.
1
Screw on the underfloor heating controller.
2
!
Take the 52 mm installation
height of the underfloor heating
controller into account!
If the underfloor heating controller is
installed upright on edge, the transformer
must be on top to ensure ventilation.
DIN rail installation
Place the housing on the DIN rail from below (1).
1
Press the housing upwards until
2
it snaps into place (2).
HCE80(R) / HCC80(R) Mounting and operation
52. 0
2
1
337
349. 5
9
Æ 4.2