Mounting The Lcd Monitor - Dometic Waeco PerfectView M5L Instructions De Montage Et De Service

PerfectView M5L, M7L, M7LX
7

Mounting the LCD monitor

7.1 Tools required (fig. <Waeco<Waeco>1, page 2)
For installation and assembly you will require the following tools:
 Measuring ruler (4)
 Centre punch (5)
Hammer (6)

 Drill bit set (7)
Drill (8)

 Screwdriver (9)
To make and test the electrical connection, the following tools are required:
 Diode test lamp (1) or voltmeter (2)
 Insulating tape (10)
 Heat shrinking sleeve
Hot air blower (11)

 Crimping tool (12)
Soldering iron, if required (13)

 Solder, if required (14)
 Cable bushing sleeves, if necessary
To fasten the cables, you may require additional cable binders.
7.2 Installing the monitor
!
CAUTION! Risk of injury!
Select the location of the monitor so that it cannot injure anybody in the vehicle
under any circumstances (e.g. sudden braking, road traffic accidents).
Observe the following installation instructions:
 Select an installation location that provides an unobstructed view of the monitor
(fig. <Waeco<Waeco>6, page 3 and fig. <Waeco<Waeco>7, page 3).
 Never install the monitor in areas where your head may impact or in the area that would
be filled by an expanding airbag. This could cause injury if the airbag opens.
 The monitor may not impair your vision when driving (fig. <Waeco<Waeco>8,
page 4).
 The installation location should be flat.
 Check that there is sufficient room underneath the installation location to attach the
washers and nuts.
 Check beforehand that there is sufficient room for the drill head to come out on the
other side (fig. <Waeco<Waeco>2, page 3).
 Bear in mind the weight of the monitor. Provide reinforcement if necessary (larger
washers or plates).
 Ensure that you can lay the connection cables to the monitor.
EN
Mounting the LCD monitor
29