Before Use; Bringing Into Use; Attaching The Spray Tube; Filling The Pressure Sprayer Tank - FLORABEST Z31339 Instructions D'utilisation Et Consignes De Sécurité

Fill the device only with liquids at
temperatures of 0 - 40 °C.

Before use

Q
CAUTION! Check that the device is
functioning properly! Check the pressure
sprayer before each use to ensure that it
is free of visible damage and is func-
tioning safely. To do this, carry out the
following tests and inspections:
j
C heck the tank
and the carry strap
j
C heck that the hose connections are fitted
tightly.
j
C heck that the pipe connections are fitted
tightly.
j
P ump the empty pressure sprayer to
approx. 2 bar.
The pressure must not fall more than ap-
prox. 0.5 bar in a space of 30 minutes.
j
P ump the pressure sprayer to approx.
2 bar.
j
P ull the safety valve
You must be able to hear the pressure
escaping.

Bringing into use

Q

Attaching the spray tube

Q
(Fig. B)
j
T urn the union nut
release it from the handle
spray tube into the handle
8
far as it will go.
j
T ighten the union nut
clockwise.
8 GB/IE
, the suction hose
5 12
for visible damage.
6
up to the stop.
3
anticlockwise to
10
. Push the
11
as
11
by turning it
10
Filling the pressure
Q
sprayer tank (Fig. D)
Note: Before using the product, check to
see that it is in good condition and free of
defects.
j
P ress the pump handle
and turn it anticlockwise.
Note: Before you open the tank, pull
the safety valve
any residual pressure still present in the
container .
5
j
D raw the pump
.
5
j
N ow fill the tank. Ensure that the use of
the pesticide, liquid fertiliser or cleaning
agent is permitted in your country and
that it is compatible with your pressure
sprayer.
Note: Fill the tank with only the
amount of liquid that you actually need
for that particular spraying session (not
more than 5 l).
j
P lace the pump
tainer and turn the pump handle
5
clockwise as far as it will go.
Building up the operating
Q
pressure
j
M ove the pump handle
until the pressure sprayer has been
pumped up to a pressure not exceeding
the maximum permissible operating
pressure of 2.5 bar. To ensure this value
is not exceeded, monitor the pressure
gauge during the pumping process.
4
Note: If the pressure of the air in the
container exceeds 2.5 bar, the pres-
5
sure is automatically released through
the safety valve
downwards
1
upwards to release
3
out of the container
2
back into the con-
2
up and down
1
.
3
1