Brink 3327 Instructions De Montage page 5

GB
Couplings class
Approval number
D- Value
Max. trailers dimensions
Max. vertical load
FITTINGINSTRUCTIONS:
1. Place the side plates A and B on the inside of the chassis. Push the
M16 120 bolts through the C holes in the chassis via the outside.
Tighten the whole locally by means of two nuts with spring washers.
Place plate D in the middle under the vehicle and fasten this at points
E to the corresponding threaded holes by means of two bolts M14x80
with washers and spring washers.
2. Secure two M12x30 bolts with washers and spring washers and nuts at
hole F. Fasten the flange ball bearing according to sketch by means of
two M16x60 bolts with spacer plate, washers, and nuts. Fasten four
M16x45 bolts with washers and nuts at the remaining holes. Tighten all
nuts and bolts in accordance with the table.
The socket plate can be fitted on the left or right, depending on the fitting
material that comes with the cable set.
:
A 50-X
:
e11 00-2066
:
15,5 kN
:
3500 kg
:
150 kg
NOTE:
* Should this installation process entail the cutting of the bumper –
conformation MUST be obtained by the installation engineer of
the customer's acceptance prior to completion. Brink Towing
Systems do not accept responsibility for any matters arising as a
result of this miscommunication.
* All measurements are in mm!
* The dealer should be consulted for possible necessary adjustment(s)
"of the vehicle".
* Remove the insulating material from the contact area of the fitting
points.
* Consult your dealer for the maximum tolerated pull weight and ball
hitch pressure of your vehicle.
* Do not drill through electrical-, brake- or fuellines.
* Remove (if present) the plastic caps from the spot welding nuts.
* This fitting instruction has to be enclosed in the vehicle documents after
fitting the towbar.
* Brink is not liable for damage caused directly or indirectly by incorrect
assembly, including the use of unsuitable tools, the use of other
assembly methods and means than the ones outlined, and the incor-
rect interpretation of these assembly instructions.
Torque settings for nuts and bolts (8.8):
M12 79 Nm
M14 125 Nm
M16 195 Nm
© 332770/05-03-2012/4