Edge And Profile Cutting; Milling With Parallel Stop; Milling With Template Guide; Milling With Centring Tip - Parkside POF 1200 C2 Traduction Des Instructions D'origine

GB IE
Fasten the machine again using the
clamping lever.
6. Hold the machine tightly with both
hands while working and mill with an
even feed.
7. After work, loosen the clamping lever
( 19) and move the machine up-
ward.
8. Turn off the device.

Edge and profile cutting

When edge or profile cutting with-
out parallel stop, the cutter must be
equipped with a stop ring (a) as
a
guide.
1. Move the turned on machine to the
workpiece until it sits on the stop ring
on the workpiece edge to be pro-
cessed.
2. Move the machine with both hands
along the workpiece edge. Avoid ex-
cessive pressure.

Milling with parallel stop

You can mill notches and profiles with the
parallel stop by moving the parallel stop
along the workpiece edge at a pre-set
distance.
1. Insert the parallel stop (24) with
the guide bars (29) into the guide
rails (15) of the baseplate (10).
Tighten the retaining screws (9).
2. Move the turned on machine
along the workpiece edge with
lateral pressure on the parallel
stop (24).
32

Milling with template guide

By means of the template guide (25), you
can transfer contours from templates to
workpieces.
Inserting the template
guide:
1. Screw off the suction adapter as
applies.
2. Insert the template guide (25) into
the sliding plate (11). The ball
race (26) must point down.
3. Fasten the template guide (25)
to the recessed head screws (21)
that are included in the delivery.
Inserting the cutter:
4. Insert a cutter that has a diameter
smaller than the inner diameter of
the template guide (25).
5. Set the desired cutting depth (see
"Initial operation").
Milling with template guide
6. Loosen the clamping lever
( 19) and lower the machine
downward until the previously set
cutting depth is reached.
7. Move the machine with protrud-
ing template guide (25) along the
template. Apply slight pressure
during this work.
The template must be at least as
high as the ball race (26) of the
template guide (25).

Milling with centring tip

By means of the centring tip, you can do
circular milling work.