Statistic Mode - AEG CG 6200 Mode D'emploi

Ground coffee was used (not beans)
and the appliance does not deliver
any coffee
• Too much ground coffee has been
added.
0 Remove the brewing unit and thor-
oughly clean the inside of the appli-
ance, as described in „Cleaning the
brewing unit", page 44. Repeat the
operation using a maximum of 2
scoops of ground coffee.
• The "Coffee strength / Pre-ground cof-
fee" knob has not been turned to the
or position and the appliance
has used both the ground coffee that
has been added and the coffee that has
been ground by the grinder.
0 Thoroughly clean the inside of the
appliance, as described in „Cleaning
the brewing unit", page 44. Repeat the
operation, first turning the "Coffee
strength / Pre-ground coffee" knob as
described in „Using pre-ground cof-
fee", page 40.
• Ground coffee has been added when
the appliance was switched off.
0 Remove the brewing unit and thor-
oughly clean the inside of the appli-
ance, as described in the section
„Cleaning the brewing unit", page 44.
Repeat the operation, but switch the
appliance on first.
What to do if the coffee machine
has to be transported
• Keep the original packaging as trans-
port protection. It is important to use
the original plastic bag as a protection
against scratches.
• Secure the coffee machine and the
thermos jug against jarring. The manu-
facturer accepts no liability for dam-
age during transportation.
• Empty the water tank and waste coffee
container.
• Care should also be taken with the
location of the coffee machine - espe-
cially in cold weather, when damage
can be caused by frost.
17

Statistic mode

The coffee machine has the facility to
indicate
– the total number of cups of coffee
made,
– the number of jugs prepared, con-
taining 4 cups, 6 cups, 8 cups and
10 cups,
– the number of descalings carried
out, as well as
– the number of liters of water dis-
pensed.
3
Where 2 cups of coffee are dispensed
simultaneously, there are also counted
as 2 cups of coffee.
To activate the statistic mode, the cof-
fee machine must be switched off.
0 If necessary, switch the machine off
with the "On/ Off" key
0 Press the "P" key (Fig. 4) for at least
6 seconds.
The symbols "P" and
thermore 3 small symbols above the
, and buttons come on to
show the present function of these
buttons, see „Special mode", page 35.
0 Repeatedly press the scrolling keys "<"
or ">" (Fig. 5) to illuminate the symbol,
for which the relevant statistic should
be indicated:
number of cups
dispensed
number of descalings
carried out
number of jugs with 4 cups
4
dispensed
number of jugs with 6 cups
6
dispensed
number of jugs with 8 cups
8
dispensed
number of jugs with 10 cups
10
dispensed
number of liters of water
dispensed
When a symbol is illuminated, you can
indicate the related number as follows:
g
(Fig. 11).
come on. Fur-
49