Using Pre-Ground Coffee - AEG CG 6200 Mode D'emploi

g
3
If there are either not enough coffee
beans or there is too little water to
complete the requested operation, or
the waste coffee container is full, the
machine will stop the operation and
the current program is cancelled. After
the error has been rectified, the pro-
gram must be restarted. The amount of
coffee already in the jug must be taken
into consideration, so that the jug is
not over-filled.
3
If the symbols and
the coffee is ground too fine. You
should change the grinding setting; see
„Setting the grinding texture",
page 42.
8

Using pre-ground coffee

This function allows you to brew pre-
ground coffee, e.g. decaffeinated
coffee.
1
Make sure that no ground coffee has
remained in the filler, and that no for-
eign objects enter the filler. The ground
coffee filler is not a storage container.
The ground coffee must be fed directly
into the brewing unit.
0 Turn the "Coffee strength / Pre-ground
coffee" knob (Fig. 20) to the desired
position (for 1 cup) or
cups) to select the pre-ground coffee
function. This disables the coffee mill
function. One symbol
both symbols
illuminated.
0 Open the lid of the ground coffee filler,
and scoop in the fresh ground coffee
(Fig. 21).
Use only the supplied measuring
spoon. Never add more than 2 level
measured scoops, otherwise either the
appliance will not make the coffee, the
ground coffee will be dispersed inside
the appliance, dirtying it, or the coffee
will be delivered drop by drop and the
symbols and
Do not add ground coffee during the
brewing process. Only put in ground
coffee for the next cup when the
40
1
are flashing,
3
0 Close the lid.
0 To choose the required cup size, turn
0 Press the key for "1 cup"
(for 2
3
(for 1 cup) or
(for 2 cups) are
3
are flashing.
brewing process has completely fin-
ished and the coffee machine is ready.
Never add the ground coffee when the
appliance is off, as otherwise it will be
dispersed inside the appliance.
Use only ground coffee for fully auto-
mated espresso coffee makers. Do not
put coffee beans, any water-soluble or
freeze-dried instant products or any
other drink powder into the ground
coffee filler. Coffee powder which is
too fine can lead to blockages.
If the filler shaft is blocked (due to
moisture inside the appliance, or
because more than 2 measuring scoops
of pre-ground coffee have been used),
use a knife or a spoon handle to push
the coffee down (Fig. 22). Then remove
the brewing unit and clean it and the
appliance as described in the section
„Cleaning the brewing unit", page 44".
the knob for "Cup size" (Fig. 12) as
described in the section „Making cof-
fee with beans", page 37.
one cup, or the key for "2 cups"
make 2 coffees.
The coffee is prepared.
If the pre-ground coffee function for
1 cup has been selected and the
ground coffee has not been filled into
the ground coffee filler, after pressing
the button the symbols
are flashing. If the pre-ground coffee
function for 2 cups has been selected
and the ground coffee has not been
filled into the ground coffee filler,
after pressing the button the sym-
bols and are flashing.
Once the coffee has been prepared, to
go back to making coffee using beans,
turn the "Coffee strength / Pre-ground
coffee" knob (Fig. 20) to any coffee
strength setting (the coffee mill is ena-
bled for operation again).
to make
to
and