Problems That Can Be Resolved Before Calling The Customer Service Centre - AEG CG 6200 Mode D'emploi

• The coffee runs off too slowly.
0 Turn the knob for setting grinding tex-
ture (Fig. 12) one click clockwise whilst
the grinder is grinding beans for the
preparation of next coffee (see „Set-
ting the grinding texture", page 42).
The symbol is on steady
• The waste coffee container is full.
0 Empty the waste coffee container and
clean it as described in the section
„Emptying the waste coffee container",
page 44, then replace it.
The symbol is flashing
• The waste coffee container has proba-
bly not been replaced after cleaning.
0 Open the service door and insert the
waste coffee container.
The symbols or
flashing
• With the ground coffee function
selected, ground coffee has not been
poured into the ground coffee filler.
0 Add the ground coffee as described in
chapter „Using pre-ground coffee",
page 40.
All coffee strength symbols
and
• The coffee beans have run out.
0 Fill the coffee bean container, see „Fill-
ing the coffee bean container",
page 35
• If the coffee grinder is very noisy, this
could mean a small stone in the coffee
beans has blocked the grinder.
0 Contact the Customer Service Centre.
Blocking or damage caused by for-
eign objects in the grinder might be
excluded from the guarantee.
The symbol is on steady
• This indicates the presence of limescale
in the appliance.
0 The descaling procedure, described in
the section „Running the descaling
program", page 45, needs to be per-
formed as soon as possible.
• The service door is open.
0 Close the service door. If the service
• The brewing unit has probably not
0 Insert the brewing unit; see „Cleaning
• The inside of the appliance is very dirty.
0 Thoroughly clean the inside of the
and are
• This indicates a general alarm.
0 Contact the Customer Service Centre.
• The machine has been switched on
0 Turn the steam knob clockwise (Fig. 10)
are flashing
• The ambient temperature is too low to
0 Use the appliance in a warmer room.
16
The symbol is on steady
door cannot be closed, check that the
brewing unit is inserted correctly (see
„Cleaning the brewing unit", page 44).
The symbol is flashing
been replaced after cleaning.
the brewing unit", page 44
appliance; see „Cleaning the brewing
unit", page 44. If the message is still
displayed after cleaning, contact the
Customer Service Centre.
The symbol is on steady
The symbols and are flashing
with the steam knob in open position
.
as far as it will go, to the position
The symbols and are flashing
operate the applience.
Problems that can be
resolved before calling the
Customer Service Centre
If the appliance is not working, the
causes of the malfunction can be iden-
tified and resolved by referring to
chapter „What to do if you see the fol-
lowing symbols on the display ...",
page 46. If, on the other hand, no sym-
bol is displayed, run the following
checks before calling the Customer
Service Centre.
g
.
47