Regulatory Agency Approvals - 3M M1500SS Guide D'utilisation

3M™ MicroTouch™ Display M1500SS User Guide
Table 4 Common Sensor Installation Issues
Common Installation Issues Possible Solutions
Sensor does not respond to touch  Review the installation procedures. Are all cables connected
Sensor is not accurate
Cursor does not follow finger
movement or does not reach the
edges of the screen
Cursor is not located directly
underneath your finger
Cursor is extremely jittery or
erratic

Regulatory Agency Approvals

Your product complies with the following regulatory standards:

FCC-B

CE

UL/cUL

CCC

RCM
This equipment has been tested and found to comply within limits for a Class B digital
device, pursuant to Part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in residential installations. This
equipment generates, uses and can radiate radio frequency energy, and if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause interference to radio or television
equipment reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
 Reorient or relocate the receiving antenna.
 Move the equipment away from the receiver.
 Consult the dealer or an experienced radio/television technician for additional
suggestions.
properly?
 After you installed touch software, did you restart your PC to
activate the touch driver?
 Are the communication settings correct? Is the touch sensor
trying to use the COM port or IRQ of another device (for example,
a mouse)? If so, a hardware device conflict will result and the
touch sensor will not work.
 Calibrate the touch sensor for the current video resolution and
operating system.
 Calibrate the touch sensor for the current video resolution and
operating system.
 Open the touch sensor control panel and make sure all cursor
offsets (vertical, edge/horizontal) are turned off.
 Calibrate the touch sensor for the current video resolution and
operating system.
 Stabilize the cursor by adjusting the operating frequency of the
controller using the control panel.
3M Touch Systems, Inc. Proprietary Information
21