Double Insulation For Safer Operation - Metabo CR 13VBY Mode D'emploi Et Instructions De Securite

9. Keep all screws, bolts and covers tightly in place.
Keep all screws, bolts, and plates tightly mounted.
Check their condition periodically.
10. Do not use power tools if the plastic housing or
handle is cracked.
Cracks in the tool's housing or handle can lead to
electric shock. Such tools should not be used until
repaired.
11. Blades and accessories must be securely mounted
to the tool.
Prevent potential injuries to yourself or others.
Blades, cutting implements and accessories which
have been mounted to the tool should be secure
and tight.
12. Keep motor air vent clean.
The tool's motor air vent must be kept clean so
that air can freely flow at all times. Check for dust
build-up frequently.
13. Operate power tools at the rated voltage.
Operate the power tool at voltages specified on its
nameplate.
If using the power tool at a higher voltage than
the rated voltage, it will result in abnormally fast
motor revolution and may damage the unit and
the motor may burn out.
14. Never use a tool which is defective or operating
abnormally.
If the tool appears to be operating unusually,
making strange noises, or otherwise appears
defective, stop using it immediately and arrange
for repairs by a metabo HPT authorized service
center.
15. Never leave tool running unattended. Turn power
off.
Don't leave tool until it comes to a complete stop.
16. Carefully handle power tools.
Should a power tool be dropped or struck against
hard materials inadvertently, it may be deformed,
cracked, or damaged.
17. Do not wipe plastic parts with solvent. Solvents
such as gasoline, thinner benzine, carbon
tetrachloride, and alcohol may damage and crack
plastic parts. Do not wipe them with such solvents.
Wipe plastic parts with a soft cloth
lightly dampened with soapy water and dry
thoroughly.
MAKE THEM AVAILABLE TO OTHER USERS
SAVE THESE INSTRUCTIONS
AND
AND
OWNERS OF THIS TOOL!
18. ALWAYS wear eye protectors during operation.
19. ALWAYS be careful with buried objict such as an
underground wiring.
Touching these active wiring or electric cable with
this tool, you may receive an electric shock.
Comfirm if there are any buried object such as
electric cable within the wall, floor or ceiling where
you are going to operate here after.
20. Definitions for symbols used on this tool
V .............................. volts
Hz ............................ hertz
A .............................. amperes
n
............................ no load speed
o
W ............................. watt
............................. Class II Construction
---/min ..................... revolutions or reciprocation
............................. Alternating current
DOUBLE INSULATION FOR SAFER
OPERATION
To ensure safer operation of this power tool,
metabo HPT has adopted a double insulation design.
"Double insulation"
separated insulation systems have been used to
insulate the electrically conductive materials connected to
the power supply from the outer frame handled by the
operator. Therefore, either the symbol " " or the words
"Double insulation" appear on the power tool or on the
nameplate. Although this system has no external
grounding, you must still follow the normal electrical
safety precautions given in this Instruction Manual,
including not using the power tool in wet environments.
To keep the double insulation system effective, follow
these precautions:
Only metabo HPT AUTHORIZED SERVICE CENTER
should disassemble or assemble this power tool,
and only genuine metabo HPT replacement
parts should be installed.
Clean the exterior of the power tool only with a
soft cloth moistened with soapy water, and dry
thoroughly.
Never use solvents, gasoline or thinners on plastic
components; otherwise the plastic may dissolve.
English
per minute
means that two physically
5