Cleaning And Storage; Troubleshooting - MAXXMEE 04245 Mode D'emploi

EN

CLEANING AND STORAGE

Please Note!
■
Do not use any caustic or abrasive
cleaning agents to clean the device.
These could damage the surface. Do
not use any metal objects to remove
dirt from the bottom of the iron.
• If necessary, wipe down the device
with a damp cloth and then allow it
to dry.
• If there is no longer any water in the
water tank (7) (see the "Use" chapter
– "After Use"), wind up the connect-
ing cable.
• Store the device in a dry, clean, frost-
free place that is not accessible to
children and animals.
Self-Cleaning Function
Please Note!
■
Hot water and steam will emerge
from the bottom of the iron during
the self-cleaning process. Keep the
bottom of the iron away from all body
parts and delicate materials when the
On / Off button for self-cleaning is
pressed!
■
Only ever press the On / Off button
for self-cleaning to perform self-clean-
ing and not during ironing!
 
As the temperature drops quickly
with this function, we recommend
that the iron should be connected
to the adapter (11) and connect-
ed to the mains power.
The device has a self-cleaning function al-
lowing limescale residues to be removed
from the device. Additional descaling of
the device is not necessary. Perform the
following operations:
22
1. Make sure that the water tank (7) is
fi lled (see the "Filling the Water Tank"
section).
2. Connect the iron to the adapter (11)
and plug the mains plug into a plug
socket.
3. Place the iron with the adapter
upright on the ironing board or on a
stable, heat-resistant and moisture-re-
sistant surface.
4. Use the temperature control dial (15)
to select the temperature level MAX
and allow the device to heat up.
5. Hold the iron horizontally over a sink
or similar outlet.
6. Press and hold the self-cleaning but-
ton (13).
7. Allow the water tank to empty com-
pletely. Tilt the iron back and forth
slightly to allow the water to run out
of all nozzles.
8. Repeat the cleaning process several
times until no more limescale residues
emerge from the nozzles.

TROUBLESHOOTING

If the device does not work properly,
check whether you are able to rectify the
problem yourself. If the problem cannot
be solved with the steps below, contact
the customer service department.
Do not attempt to repair an elec-
trical device yourself!
The device does not work.
The mains plug is not inserted in the plug
socket correctly.
► Correct the fit of the mains plug.
The plug socket is defective.
► Try another plug socket.
There is no mains voltage.
► Check the fuse of the electrical dis-
tributor (fuse box).