Ironing Recommendations; Use - MAXXMEE 04245 Mode D'emploi

Steam Iron

IRONING RECOMMENDATIONS

• Check before ironing whether the garment which is to be ironed has a label with
ironing instructions on it and follow them. Otherwise select the ironing temperature
based on the type of fabric. The recommended temperature and steam settings are:
Label
Synthetics (e.g. nylon, viscose)
Silk
Wool
Cotton
Linen
Materials which must not be ironed
• With blended fabrics base the temperature setting on the most delicate blended
fi bre.
• Sort the textiles based on the ironing temperature and start with the garments
which require the lowest temperature. If the temperature on the device is reduced,
wait a short while until the bottom of the iron has cooled down and then continue
ironing.
• Iron delicate textiles inside out.

USE

Please Note!
■
If there are water residues in the water
tank, rinse it out with fresh water and
activate the steam production until all
the water evaporates (see the "Use"
chapter – "Filling the Water Tank" and
"After Use").
■
Before the iron is used on an item of
clothing for the fi rst time, iron over a
damp scrap piece of fabric to remove
any possible production residues from
the bottom of the iron.
The water tank (7) needs to be fi lled with
water for steam-ironing and spraying.
This is not necessary for dry-ironing.
Material
Filling the Water Tank
Please Note!
■
■
1. Make sure that the device is not
2. Flip open the water tank lid (2).
3. Use the measuring cup to pour tap
4. Flip the water tank lid shut.
Tempera-
ture
•
••
•••
MAX
Do not overfi ll the water tank! Do
not exceed the MAX marking on the
water tank.
Never pour additives into the water
tank. These could damage the device.
connected to the mains power and is
not hot.
water or distilled water into the fi ller
opening of the water tank (7).
EN
Steam
No steam
Steam, medium
Steam, strong
19