MELICONI AT52 Mode D'emploi page 5

INDOOR AMPLIFIED ANTENNA
INSTRUCTIONS FOR USE
Thank you for choosing a MELICONI product.
The Meliconi AT 52 indoor amplifi ed antenna can receive and amplify digital terrestrial TV
signals and DAB radio signals on VHF bands (band III - 174~230 MHz) and UHF bands
(470~790 MHz).
The antenna can be connected to a television or a digital terrestrial decoder.
A
• The product is for internal use only; do not use outdoors.
• Keep away from water: the appliance must not be exposed to dripping or splashing water. Do
not use in damp surroundings.
• The product must not be exposed to sources of excessive heat, such as solar radiation, fi re
or similar.
• Do not use a power supply other than the one provided with the appliance.
• The AC adaptor must be readily accessible so that the device can be easily disconnected from
the power supply.
• If you notice any faults in the AC adapter, disconnect it immediately from the socket.
• To avoid electric shock, do not tamper with the appliance or attempt to repair it.
• The product is not a toy; it must not be left within reach of children or pets.
• Before setting up the connections, disconnect the appliances from the power supply.
B
• Place the antenna in a favourable position, for example near a window and/or toward a tv
transmission tower; away from metal objects, electrical appliances and reinforced concrete
walls that would restrict its functioning.
• Connect the Meliconi antenna to the antenna socket at the back of the television or digital
terrestrial decoder, using the specifi c cable. If the decoder antenna socket is F-female type,
obtain a F-male/IEC-female adapter (not included in the box).
• Use the AC/DC power supply included in the box to power the antenna; insert the cable into
the antenna power input and connect the power supply to a 230V~/50Hz electrical outlet.
• Push button A on the power supply plug to turn the antenna on and than rotate
counterclockwise the knob (B) on the back of the antenna, to set it to maximum amplifi cation.
• LED on, indicates that connection to the power supply is correct.
• Switch on the device (TV/DECODER) and select the desired channel.
• The power can be supplied directly from the antenna cable on specifi c TV or DECODERS
(see user manual for the TV/DECODER device).
AT52
Safety warnings
Installation
(see fi gures 2 and 3 for connections)
EN
3