Cleaning & Maintenance - Envion thera pure TPP240 Mode D'emploi

13
CLEANING & MAINTENANCE
Keep the Therapure
®
weeks of use. More frequent cleaning will be necessary if the unit is located in an area with a high level
of airborne contaminants (excessive amounts of smoke, pet dander, etc.).
Exposing the Therapure
require more frequent cleaning.
Note: Always make sure the Therapure
» Vacuuming will restore performance of the Cleanable HEPA-Type Filter. However,
the filter may appear stained. This is normal and does not affect performance in any way.
» Do not use water or any household cleaners or detergents to clean the Cleanable
HEPA-Type Filter.
» The inlet grill may be cleaned (after unit is turned off and unplugged) with a vacuum
or a slightly damp cloth.
Cleaning the Cleanable HEPA-Type Filter
1. Release the inlet grill by pressing on the locking latch (see diagram of Main Parts).
2. Remove the inlet grill from the unit as shown below.
3. Grasp the left and right frames of the Cleanable HEPA-Type Filter through the indentations on
the sides of the filter enclosure and remove the filter.
4. To clean the Cleanable HEPA-Type Filter, use the brush or crevice attachment with a vacuum
cleaner. Run the attachment along the inlet and outlet side of the filter, cleaning between the
crevices as much as possible. Do not use water or any household cleaners or detergents
to clean the Cleanable HEPA-Type Filter.
5. Once the Cleanable HEPA-Type Filter has been cleaned and checked for any possible damage,
replace the filter back in the reverse direction described here. Plug in the unit and hold down
Time + Power On button for 3 seconds. The clean filter light will go off and your cleaning
maintenance is done.
1.
240 functioning properly by cleaning the Cleanable HEPA-Type filter every four
240 to candle/oil/fireplace soot and smoke is not recommended and will
®
240 is turned off and unplugged before cleaning.
®
2. 3. 4.
TPP240