Controls/Settings; Cleaning & Maintenance - Envion thera pure TPP620 Mode D'emploi

OPERATING THE THERAPURE

CONTROLS/SETTINGS:

Power Control – To operate the Therapure
®
air purifier. Far left is OFF.
Fan Speed Control – The Therapure 620 has three different speeds of cleaning, LOW, MED and HI.
®
Turn the Control Dial to cycle the settings and select the fan speed you desire.
Clean Filter Indicator Light – The Therapure
time for the filter to be cleaned. To reset the filter indicator for 3 seconds. The CLEAN FILTER light will
flash 3 times and then turn off completely, indicating the unit has been reset.
UV Control – Press the "UV/VOC" control button for UV/VOC to turn on the UV lamp and the
photocatalyst filter.
TPP620
TPP620
®
620, turn the Control Dial to turn on the
620 Clean Filter Indicator Light will turn Red when it's
®
Clean Filter
Indicator Light
UV
Button
Control
Dial
12 13
CLEANING & MAINTENANCE
Keep the Therapure 620 functioning properly by cleaning the cleanable HEPA-Type Filter every four
®
weeks of use. More frequent cleaning will be necessary if the unit is located in an area with a high level
of airborne contaminants (excessive amounts of smoke, pet dander, etc.).
Exposing the Therapure 620 to candle/oil/fireplace soot and smoke is not recommended and will
®
require more frequent cleaning.
Note: Always make sure the Therapure
» Vacuuming will restore performance of the cleanable HEPA-Type Filter. However,
the filter may appear stained. This is normal and does not affect performance in any way.
» Do not use water or any household cleaners or detergents to clean the cleanable
HEPA-Type Filter.
» The inlet grill may be cleaned (after unit is turned off and unplugged) with a vacuum
or a slightly damp cloth.
Cleaning the cleanable HEPA-Type Filter
1. Release the inlet grill by pressing on the locking latch (see diagram of Main Parts).
2. Remove the inlet grill from the unit as shown below.
3. Grasp the top & bottom tabs on the filter frame of the cleanable HEPA-Type Filter.
on the sides of the filter enclosure and remove the filter.
4. To clean the cleanable HEPA-Type Filter, use the brush or crevice attachment with a vacuum
cleaner. Run the attachment along the inlet and outlet side of the filter, cleaning between
the crevices as much as possible. Do not use water or any household cleaners or detergents
to clean the cleanable HEPA-Type Filter.
5. Once the cleanable HEPA-Type Filter has been cleaned and checked for any possible damage,
replace the filter back in the reverse direction described here. Plug in the unit and hold down
the UV/VOC button for 3 seconds. The clean filter light will go off and your cleaning maintenance
is done.
1.
3.
620 is turned off and unplugged before cleaning.
®
2.
4.
TPP620