Gladiator GEARTRACK Instructions D'installation page 8

3.
Measure Location of Remaining Studs
16''(40.64 cm)
Use this stud as your guide. Measure 16" (40.64 cm) from
■
the corner and snap a vertical chalk line using a chalk line
with a plumb bob. Snap a chalk line every 16" (40.64 cm)
from this point.
Wood Studs and Drywall over Wood Studs
1.
Locate Studs and Electrical
Use a stud finder to mark the edges of the studs within
■
your planned installation area. Be sure to also mark the
locations of electrical wiring.
IMPORTANT: Compare screw length to electrical wiring
locations. Be sure the screw will not pierce electrical
wiring.
16''(40.64 cm)
4.
Mount Remaining Studs
Align the center of the stud with the chalk line. Attach the
■
remaining studs to the wall as you did in steps 1-2.
8