Quality From The Very Start - Brita MAXTRA Mode D'emploi

II.

Quality from the very start

To ensure that you get the best results from your BRITA water fi lter,
please follow the instructions carefully.
1 Cleaning instructions for your new
BRITA water fi lter before fi rst use and
every cartridge exchange
Funnel and jug
Clean the funnel and jug in the dishwasher or
by hand.
Lid with BRITA Meter
The lid is dishwasher-safe.
Before cleaning the lid in the dishwasher
please remove the BRITA Meter from the
lid. Press the two tongues on each side of
the BRITA Meter and tilt the BRITA Meter
back towards the handle cover for complete
removal.
The removed BRITA Meter must not be
washed in the dishwasher. Clean the removed
BRITA Meter by hand.
Lid with BRITA Memo or
BRITA Calendar
The lid must not be washed in the dishwasher.
Clean the lid by hand.
BRITA water fi lter with a tap spout
Please pass warm water through the tap
spout, and you may wipe it internally with a
cotton bud or similar. The tap can be easily
disassembled by screwing off the cap located
under the lever and then cleaning the spout
and components.
Please use mild detergents but no
abrasive cleaners. For descaling lid and
BRITA Meter use common household
citric acid based descaling fl uids.
10
ENGLISH
2 Preparation of the MAXTRA cartridge
Fill the clean jug with cold water.
Remove the protective wrapper from the
MAXTRA cartridge (Note: The new MAXTRA
cartridge may be damp from steam sterilisa-
tion).
Immerse the MAXTRA cartridge in cold water
and shake it gently to remove any air bubbles.
Remove the MAXTRA cartridge and discard
the used water.
3 Insert the MAXTRA cartridge
Insert the funnel into the jug.
Place the MAXTRA cartridge into the hollow
of the funnel and push downwards until it
"clicks" fi rmly into place.
4 Filling of the BRITA water fi lter jug
The fi lling method depends on the features in
the lid of your BRITA water fi lter model.
The water in the funnel is automatically fi ltered
and fl ows into the jug.
Variants of the lid
BRITA water fi lter with automatic pour
through lid
If your BRITA water fi lter features BRITA Meter
please turn the lid on the back and insert the
BRITA Meter into the lid. Put the hook under
the "START" button into its assembly jig in the
lid. Tilt the BRITA Meter forward until it "clicks"
fi rmly into place.
5