Safety Instructions Related To The Product And Technology - Aventics HF03 Mode D'emploi

46 AVENTICS | HF03/HF02 | 1987765472–BDL–001–AB
For your safety
During assembly
W
You may only commission the product if you have determined
that the end product (such as a machine or system) in which
the AVENTICS products are installed meets the country-
specific provisions, safety regulations, and standards for the
specific application. A 24 V power pack supplies all
components with electricity. The power pack must be fitted
with a safe isolation in accordance with EN 60742, VDE 0551
classification. The corresponding electrical circuits are thus
SELV/PELV circuits in accordance with DIN EN 60204-1.
2.6 Safety instructions related to the product
and technology
W
Do not place any mechanical loads on the device under
circumstances. Do not place any objects on it.
W
Ensure that the power supply is within the stipulated
tolerance for the modules.
W
Observe the safety notes found in your valve system's
operating instructions.
W
A 24 V power pack supplies all components with electricity.
The power pack must be fitted with a safe isolation in
accordance with DIN EN 60742, VDE 0551 classification.
This ensures that the electric circuits comply with SELV/
PELV electric circuits in accordance with IEC 60364-4-41.
W
Switch off the operating voltage before connecting or
disconnecting plugs.
W
The warranty only applies to the delivered configuration. The
warranty will not apply if the product is incorrectly assembled.
W
Make sure the relevant system component is not under
pressure or voltage before assembly or disassembly.
Ensure that the system is prevented from power restoration
during assembly work.
W
Ground the modules and valve system. Observe the
following standards when installing the system:
– DIN EN 50178, classification VDE 0160
– VDE 0100