EdilKamin INPELLET 49 Installation, Usage Et Maintenance page 31

N.B.: IMPORTANT FOR INSTALLATION CONDITIONS
g. 9
E ternal
inta e
METAL FINISHING PROFILE (supplied)
If necessary, after opening the e ternal door, it is possible to
mount the "angled" metal nishing pro le on the lower base of
the structure (X - for "frame" coverings or with plasterboard)
or the " at" metal nishing pro le (Y- for "classic" coverings),
ing them using the screws supplied (see g. 1 ).
NOTES ON FITTING THE COVERING
In using a prefabricated Edil amin covering, to identify the
e act position of INPELLET 49 is important to verify the mo-
del of the covering to be used.
Positioning differs according to the model chosen (see as-
sembly instructions given in the pac aging of each covering).
lways chec that installation is perfectly vertical and horizon-
tal.
COVERINGS, COUNTER HOODS AND THEIR
VENTILATION
Before installing the covering, chec that all connections, com-
mands and moving parts are perfectly functional.
hec this with the insert on and wor ing for a few hours. Do
so prior to tting the covering in order to intervene as necessa-
ry.
Finishing wor s, such as construction of the counter-hood,
covering assembly, pilaster preparation, painting, etc.,
should be carried out once the nal test has been passed.
Edil amin will therefore not be held liable for any charges
deriving from both demolition and reconstruction wor s,
even where consequent to replacement of any faulty insert
parts.
INSTALLATION
*
Internal mantel
ventilation grilled
*
Recycled air
inta e inspection
- 31
*
There must be two ventilation grilles (surfaces greater than
cm ); the rst must be at a height which is lower than the
hearth, while the second must at a height greater than
with respect to the upper pro le of the outlet.
These grilles prevent the accumulation of heat inside, which is
then used to help heat the room of installation.
X
g. 1
Rather, at least cm. (appro .) space must be left to allow
air to ow, thereby preventing heat from accumulating.
The counter hood can be created from reproof plaster
board panels or plaster sheets.
circulation grill must be included, as previously speci ed.
THE MANTEL CAN BE CONSTRUCTED
RESISTANT PANELS IN PLASTERBOARD OR
GYPSUM BOARD.
AERATION GRILLES FOR PREVENTING ANY
EXCESS TEMPERATURE INSIDE MUST BE PROVI
DED FOR DURING CONSTRUCTION ( g. ).
During the construction phase of the covering it is funda
mental to ensure that the combustion air is restored
to prevent pressure phenomena in the room where the
replace is installed (refer to the Chapter regarding the
e ternal air inlet on page 2 )
In addition to the above, always consider the indications gi
ven by paragraphs 4.4 and 4. of standard UNI 0683/2005
insulation, nishes, coverings and safety recommenda
tions".
-
cm
Y
hen creating this, the air
ITH FIRE