First Use Of The Tm13 - Marmitek TM13 Guide Utilisateur

• The KR22 wireless remote control (an
attractive extra-slim remote control for
operation of Marmitek X-10 Modules from
a distance. Can be used as a key ring. Can
be used to control three addresses +
dimmer function.)
• The MS13 wireless motion sensor with
memory (switches lighting and appliances
on when someone is present and switches
them off again afterwards. Switches on
interior and exterior lighting when arriving
home in the dark.)

FIRST USE OF THE TM13

1. Set the HouseCode (A to P) of the Home
Control TM13 Transceiver to the same code
as you have set your other modules. The
UnitCode cannot be set and will always be
'1'. If the TM13 is set to HouseCode 'P', all
commands from remote controls will be
converted into an X-10 signal over the
mains, regardless of the HouseCode. The
HouseCode used will in this case be the
same as the HouseCode of the remote
control.
2. Point the antenna upwards.
3. Plug the Home Control TM13 into a socket
(preferably in a central location of your house).
4. Insert the plug of an appliance or light in
the module. This can now be controlled
using the '1' button of your remote.
(Does not apply to TM13EFL.)
Normally speaking, only one TM13 will be
required per installation if wireless controllers
are used that are set to the same HouseCode.
The TM13 includes a so-called 'collision
6 © MARMITEK