Changing The Collet Chuck; Fitting The Rip Fence; Setting Up; Switching On And Off - Parkside POF 1200 D3 Traduction Des Instructions D'origine

Changing the collet chuck

NOTE
► All of the cutters in the supplied cutter set are
equipped with an 8 mm shank.
Use the pre-assembled collet chuck
with them. When using milling cutters with a
6 mm shank, replace the collet chuck as
described below.
♦ Press the spindle locking button
down.
♦ Undo the union nut anticlockwise with the
open-ended spanner
(8 mm) can be removed.
♦ Fit the collet chuck
ATTENTION! Do not tighten the union nut
with the open-ended spanner
tool is fitted. Otherwise, the collet chuck may be
damaged.
♦ Release the spindle locking button

Fitting the rip fence

♦ Undo the wing screws
♦ Push the sliding rods
openings next to the wing screws. Retighten the
wing screws for the sliding rods.

Setting up

Switching on and off
Switching on
♦ Press the safety lock-out
♦ Press the ON/OFF switch
machine is running, you can release the safety
lock-out .
Switching off
♦ Release the ON/OFF switch
POF 1200 D3
(8 mm)
and hold it
until the collet chuck
(6 mm).
unless a milling
.
for the sliding rods.
into the corresponding
and hold it down.
. Once the
.

Preselecting the rotation speed

♦ Set the required speed using the adjusting
wheel for speed preselection
1–2 = low speed
3–4 = average speed
5–7 = high speed

Setting the milling depth

♦ Make sure that the clamping lever
If it is released, turn it anticlockwise until it is
locked.
♦ Place the appliance onto the workpiece.
♦ Rotate the step stop
lowest position (0 mm).
The depth stop is now in line with the lowest
position (0 mm).
♦ Undo the locking screw
♦ Release the clamping lever
clockwise and pushing the appliance down-
wards until the milling machine is touching the
surface of the workpiece.
♦ Lock the clamping lever
clockwise.
♦ Slide the depth stop
reaches the lowest position (0 mm) of the step
stop .
♦ Set the depth stop
depth, tighten the locking screw
NOTE
► The values shown on the milling depth adjust-
ment scale do not correspond to the
actual milling depth. It should always be set
relative to a selected point on the milling
depth adjustment scale
♦ Now, release the clamping lever
the appliance again.
♦ Check the milling depth by means of a practical
test.
.
is locked.
until it engages in the
.
by turning it
by turning it anti-
downwards until it
to the desired milling
.
.
and raise
GB │ IE │
7 ■