Preventing Equipment From Falling Over; Specifications - Pioneer PDK-TS30 Mode D'emploi

Preventing Equipment from Falling Over

After installing the stand, be sure to take special care to ensure that the equipment will not fall over.
Secure the plasma television to both the rack and the wall surface.
Stabilizing on a rack etc.
Fix the plasma television using the screws
black) and fall-prevention straps as shown in the diagram.
Fix the racks etc. using screws for sale on the market.
Note
To stabilize the equipment on a
table, use screws that have a
nominal diameter of 4 mm (5/32
inch) and that are at least 20 mm
(13/16 inch) long.
Screws 3
(M4 x 10 mm: black)
Screws
(commercially available)
Make a pilot hole in the rack's top
board (center of the board's
thickness), and fix the strap with a
store-bought screw.

Specifications

External dimensions:
PDK-TS30 ................ 920 mm (W) × 222.4 mm (H) × 380 mm (D) (36-7/32 in. (W) × 8-3/4 in. (H) × 14-31/32 in. (D))
PDK-TS30A ............. 922 mm (W) × 222.4 mm (H) × 381 mm (D) (36-5/16 in. (W) × 8-3/4 in. (H) × 15 in. (D))
Weight:
PDK-TS30 ................ 5.7 kg (13.0 lbs)
PDK-TS30A ............. 6.8 kg (15 lbs)
• The above specifications and exterior may be modified without prior notice to improve the product.
12
En
Using a wall for stabilization
1
(M4 × 10 mm:
3
2
Min. 20 mm
Note
(13/16 inch)
Use hooks, cords, and fittings that
are available on the market.
Recommended hook:
Nominal diameter M8
Length 12 mm to 15 mm (1/2 inch to 5/8 inch)
Fitting
Fall-prevention strap
Attaching falling prevention bolts (hooks)
to the plasma television.
Using strong cords to firmly stabilize it
appropriately and firmly to a wall, pillar, or
other sturdy element.
Perform this work in the same way on the left and right
sides.
1
Hook
2
Cord
12 mm to 15 mm
(1/2 inch to 5/8 inch)