Hendi 215012 Mode D'emploi page 7

Error codes display
Error codes shown on the display (6)
E01
E02
E03
E04
Cleaning and Maintenance
Attention: Always unplug the appliance from the electrical power outlet and let it cool down completely
before cleaning & storage.
Cleaning
• Never immerse the appliance in water or other
liquids.
• Clean the surface with a slightly damp cloth or
sponge with some mild soap solution.
Storage
• Before storage, always make sure the appliance
has already been disconnected from the electri-
cal outlet and cooled down completely.
Troubleshooting
If the appliance does not function properly, please
check the below table for the solution. If you are
still unable to solve the problem, please contact the
supplier/service provider.
Problems
The appliance does not switch
ON.
Cooling fan is operating even after
the appliance is switched to OFF
mode.
Possible cause
The internal temperature of the
appliance is too high. Buzzer
alarm sound is heard.
The appliance is overheated and
buzzer alarm sound is heard.
Input supply voltage is too high
(> 260V~).
Input supply voltage is too low
(<180V~).
• Never use abrasive sponges or detergents, steel
wool or metal utensils to clean the interior or ex-
terior parts of the appliance.
• Store the appliance in a cool, clean and dry place.
• Error codes shown on the digital display (6). (See
--> Error codes display)
Possible cause
- Power plug is not connected properly
with the electrical outlet.
- On/OFF (1) button is not pressed.
- This is normal. The cooling fan contin-
ues running in OFF mode for some time
to cool down all internal elements.
Possible solution
Press ON / OFF (1) button to switch OFF the
appliance and unplug the appliance, wait
until the appliance is completely cool down.
Also RESET the Hi-limiter.
Press ON / OFF (1) button to switch OFF the
appliance and unplug the appliance, wait
until the appliance is completely cool down.
Also RESET the Hi-limiter.
Make sure that the appliance is connected
to a suitable electrical power supply.
Make sure that the appliance is connected
to a suitable electrical power supply.
Possible solution
- Check the power plug to make sure
it is connected properly.
- Press the On/OFF (1) button to start
operation.
- Wait until the cooling fan stops ro-
tating.
EN
7