Hendi 215012 Mode D'emploi page 5

Grounding installation
This appliance is classified as protection class I
appliance and must be connected to a protective
ground. Grounding reduces the risk of electric
shock by providing an escape wire for the electric
Touch control panel of the appliance
5 4
1. ON/OFF:
2. TIMER:
3. UP:
4. DOWN:
5. FILL OIL:
6. Digital display:
7. HEATING:
8. KEEP WARM:
Preparations before using for the first time
• Remove all protective packaging and wrapping.
• Check to make sure the appliance is undamaged.
In case of incomplete delivery and damages.
Please contact supplier (See == > Warranty).
• Clean the appliance before use (See == > Clean-
ing and Maintenance).
• Make sure the appliance is completely dry.
• Place the appliance on a horizontal, stable and
heat resist surface that is safe against water
splashes.
Switch ON
• Make sure the tap is closed and that the oil tank
has enough oil, level should be between MIN and
MAX marking.
• Connect the power plug to a suitable electrical
supply outlet.
6
Switch ON / Switch OFF
Time setting up to 15 minutes
Increase Time / Temperature
Decrease Time / Temperature
Fill oil alert indicator
Show the Time / Temperature
Heating indicator
Keep warm indicator
current. This appliance is equipped with a cord
having a grounding wire with a grounding plug. The
plug must be plugged into an outlet that is properly
installed and grounded.
8 7
3 2
• Ensure that there is sufficient ventilation. Keep a
minimum distance of 20 cm around the appliance
bottom of cookware
• Do not place the appliance in close proximity to
devices which are sensitive to disturbances by
magnetic sources (e.g. radios, tape decks).
Note: Due to manufacturing residues, the appli-
ance may emit a slight odor in the first few cycles.
This is normal and does not indicate any defect or
hazard. Make sure the appliance is well ventilated.
• Next, press the power switch at the rear side of
the appliance to connect the power supply. Green
indicator on the power switch will light up.
• Now the appliance is connected to electrical sup-
ply.
1
EN
5