Panasonic Technics SU-R1000 Mode D'emploi page 24

Settings
System control connection
You can operate this unit and Technics devices supporting system control function
(Network Audio Player, Compact Disc Player, etc.) simultaneously with ease on the
remote control.
For details, refer to the operating instructions of each device.
Coaxial digital cable
*
(not supplied)
COAXIAL OUT
Network Audio Player, etc.
: The illustration shows the example when
*
connecting with coax digital cable. Connect
the device with proper cable/terminal
supporting the device.
Using system connection cable and
audio cable
1 Disconnect the AC mains lead.
2 Connect this unit and Technics device
supporting system control function
(Network Audio Player, etc.).
• Use both of the system connection cable and
the audio cables when connecting this unit
and the device.
• Use the system connection cable supplied
with the connected device.
3 Connect the AC mains lead to this unit.
( 12)
4 Press the unit on/off button to the
[ ] position.
5 Press [SETUP].
24
(24)
System connection
cable
CONTROL
6 Press [ ], [ ] repeatedly to select
"System Control" and then press [OK].
7 Press [ ], [ ] to select the input
source for the device which is
connected at step 2, and press [OK].
• Select "Off" to disable the system control
function.
Note
• When using this unit as power amplifier ( 18),
the system control function for the Technics
device connected to the MAIN IN terminals is
disabled.
Switching this unit and the
connected device
• If you point the remote control at this unit and
press [ ] when this unit and the connected
device are in standby mode, this unit and the
device of the selected input source which is
set with "System Control" will be turned on
simultaneously.
• If you point the remote control at this unit and
press [ ] when this unit and the connected
device are turned on, this unit and the
connected device will enter standby mode.
Switching this unit's input source
automatically
When you perform an operation such as
playback on the connected device, the input
source of this unit will be automatically switched
to the source which is set with "System Control".