IKRA AHS 4054 Mode D'emploi page 33

Dear Customer
these Operating Instructions are intended to facilitate your becoming acquainted with the machine and using it in ac-
cordance with the regulations. The Operating Instructions contain important information on how to use the machine
safely, correctly and economically. Observing this information will help increase the reliability and working life of the
machine. The Operating Instructions must always be at hand when the machine is being used.
They must be read and observed by every person dealing with the machine, whether operating, servicing or trans-
porting it.
In addition to the Operating Instructions and the applicable rules of the prevention of accidents valid in the country
of use and on site, the generally recognised rules on working safely and correctly must be observed as well as the
accident prevention rules of the relevant professional associations.
Technical Data
Cordless Hedge Trimmer
Rated Voltage
Cutting Thickness
Cutting length
Speed of rotation n
0
Battery type *
Voltage / battery capacity / energy
Charging device *
Runtime
Weight
Noise Pressure Level L
Vibration
(EN 60745-2-15)
* not included in the scope of delivery
Technical changes are reserved.
- The specified vibration emission value was measured by a standardized test methods and can compare with other
power tools are used.
- The specified vibration emission value can also be necessary for the assessment of work breaks are used.
- The specified vibration emission value can vary during the actual use of the electric tool by specifying the value,
depending on the way how to use the power tool.
- Note: You create the privilege against vascular pulsations of the hands in time breaks.
- Try to keep the stress due to vibration as low as possible. For example, measures to reduce vibration stress are
wearing gloves when using the tool and limiting the work time. All phase of the operating cycle must be considered
in this regard, (for example, times when the power tool is switched off, and times when the power tool is switched
on but is not running under load).
- Always keep hands and feet away from the cutting tools, particularly when switching on the motor!
- A tingling feeling or numbness in the hands is sign of excessive vibration. Limit the operating time, take sufficiently
long work breaks, distribute the work between several people or wear anti-vibration gloves when using the tool for
extended periods.
- A certain degree of noise from this device is unavoidable. Perform noise-intensive work at times when this is per-
mitted and at times intended for this type of work. Where applicable, observe quiet times and limit working time to
the absolute minimum. You and other persons in the area where the trimmer is being used should wear suitable
hearing protection.
Noise emission information in accordance with the German Product Safety Act (GPSG) and the EC Machine Direc-
tive: the noise pressure level at the place of work can exceed 80 dB(A). In such cases the operator will require noise
protection (e.g. wearing of ear protectors).
Attention: Noise protection! Please observe the local regulations when operating your device.
pA (EN 60745-2-15)
AHS 4054
40 V DC
18 mm
540 mm
1425 min
-1
R3-360-AH-U-02
Li-Ion 40 V / 2,5 Ah / 100 Wh
R3-360-3A-02 rapid charger
R3-360-1A-02 standard charger
max. 80 min.
3,0 kg
86 dB(A) K 3,0 dB
2
< 2,5 m/s K 1,5 m/s²
GB-2