Hendi 208533 Mode D'emploi page 7

Regular maintenance
For the best coffee result and the extension of the
life span of the coffee maker, is it better to avoid the
red light on the front from lighting up (this means
de-scaling needs to be done). You should use (just
as with de-scaling) a de-scaling agent for coffee
makers or pure lemon juice, citric acid or cleaning
vinegar. To ensure the proper mixture, read the in-
structions supplied with the agent. For pure lemon
juice or cleaning vinegar the general mixture applies
of 1/3 cleaning vinegar or lemon juice to 2/3 water.
• Place an empty coffee pot under the filter pan.
Note: Warranty is void if failure to de-scale regularly leads to reduced functioning or failure of the appliance.
Technical data
Voltage
Frequency
Power
Capacity
Brewing time
Brewing temperature
Temperature after 6 hours on warming plate
Coffee filters
Measurements appliance
Glass decanter capacity
Possible problems and how to solve them
Problem
The is pressed but it does not
light up.
RED indicator lamp at the front
lower side lights up.
The is pressed and it does
light up but no function.
Appliance works, but water flow
is sometimes interrupted for
more than five minutes.
A fuse in the fuse box blows
when the appliance is turned
on.
Empty the appliance (no water can remain in the appliance) before it is repaired. If in doubt, always contact
your supplier!
• Pour the water with the solution in the water res-
ervoir.
• Turn the power switch ON.
• When all of the solution has passed through the
appliance, turn the appliance off and throw the
solution away.
• Pour clean water in the water reservoir and allow
it to flow through the appliance (see steps 1 to 7
of Preparing the appliance for use) until the smell
and taste of the solution are completely gone.
• The appliance can now be used again.
230 V
50-60 Hz
2020 W
maximum 100 cups / hour
1.8 litres / 5 minutes
93°~96°C
max. 80°C
Ø 25cm (110/250 mm)
204x380x(H)425 mm
1.8 litres
Possible cause
1. Appliance is not plugged in
properly.
2. The is broken.
1. Temperature safety device
is activated due to abnormal
operation.
2. Water level sensor is broken.
1. Heating element is broken.
2. Temperature safety device is
damaged.
1. Relay is broken.
2. Temperature safety device is
damaged.
Short circuit.
Solution
1. Insert plug into socket.
2. Contact your supplier for a
new switch.
Contact your supplier.
Contact your supplier.
Contact your supplier.
Contact your supplier.
EN
7