Hendi 208533 Mode D'emploi page 6

11. It takes about 5 to 6 minutes to brew one glass
decanter of coffee.
12. There is another warming plate at the top. You
can put the ready glass decanter on it & press
keep warming button
warm. So that you can brew another glass de-
canter of coffee at the same time using the lower
warming plate.
13. The appliance has an overflow tube to allow extra
water in the reservoir to escape, but since the
coffee pot can hold only 1.8 litres of water we
recommend that you never fill the reservoir with
more than 1.8 litres of water.
Do not forget to turn the appliance off after use.
Cleaning and maintenance
Cleaning
Important! Before cleaning, make sure to discon-
nect the appliance form the electrical power outlet
and let it cool down completely.
It is important to clean the appliance and parts after
EN
Descaling
Note: Descale the coffee machine regularly. The
intervals depend mainly on frequency of use & the
quality of the water.
After some time limestone deposits will build up on
the heating element. To keep the appliance in opti-
mum condition and to ensure that your coffee re-
tains its delicious flavour, we recommend that you
de-scale the appliance on a regular basis.
• To de-scale use a de-scaling agent that is suitable
for coffee makers. You can also use pure lemon
juice, citric acid or cleaning vinegar as a de-scal-
ing agent. To ensure the proper mixture, read the
instructions supplied with the agent. For pure
lemon juice or cleaning vinegar the general mix-
ture applies of 1/3 cleaning vinegar or lemon juice
to 2/3 water.
• Place the filter pan in the holder.
• Place an empty coffee pot under the filter pan.
6
to operate & keep it
14. Some water will always be left in the machine
and in the tubes. If you do not use or move the
appliance for a long time, it is best to empty the
appliance and clean it before storing it.
15. If you have emptied the appliance (as recom-
mended in no. 10 above), before using it again
you should repeat steps 1-7 of Preparing the ap-
pliance for use.
16. If you haven't used the appliance for a short time,
rinse it out with clean water before use.
Note: There is a RED indicator lamp at the lower
front side. It will lights up when temperature safety
device is activated for protection due to abnormal
operation. Unplug it and left cool down completely.
Contact the supplier.
using. The best way to clean grime or deposits from
the appliance, filter pan, pot or water tubes is with a
soft, wet cloth and a mild cleaner if necessary (never
use a product that is corrosive or abrasive).
• Pour the water with the solution in the water res-
ervoir.
• Turn the power switch ON.
• The water that is still in the appliance will now
pass through it. As soon as the solution begins to
flow through the appliance, turn it off.
• Wait 5-6 minutes to give the solution time to break
down the calcium in the appliance. Turn the appli-
ance on again so the solution (now containing the
calcium deposits) can pass through it.
• When all of the solution has passed through the
appliance, turn the appliance off and throw the
solution away.
• Pour clean water in the water reservoir and allow
it to flow through the appliance (see steps 1 to 7
of Preparing the appliance for use) until the smell
and taste of the solution are completely gone.
• The appliance can now be used again.