BH FITNESS H-491 Instructions De Montage page 9

GENERAL INSTRUCTIONS.-
Carefully read through the instructions
in this manual.
Make sure that the machine operates
correctly before attempting to use it.
Do not switch it on if any faults are
detected. Parents
responsible for children must always
be aware of their curious nature and
how this can often lead to hazardous
situations and behaviour which could
cause accidents For this reason they
must always be supervised by a
responsible person. This appliance
must never be used as a toy.
This appliance can only be used by
one person at a time.
ASSEMBLY INSTRUCTIONS.-
The assistance of a second person
is advisable for the assembly work.
1 Take the unit out of its box and
make sure that all of the pieces are
there, Fig.1:
(A) Main body; (6) handlebar stem;
(16) Saddle post; (11) Stabiliser bar
with wheels; (15) Stabiliser bar with
adjustable blocks; (19) Saddle; (12 R)
and (12 L) Pedals; (1) Monitor; (2)
Handlebar; Bag of screws containing:
(10) Bolts M-8 x 70; (14) Flat washers;
(13) Cap nuts M-8; (a) and (b)
Spanners; (c) Transformer (Mod.H-
493).
2 Take the stabiliser bar (15) with
adjustable blocas (Y) and position it
on the stand at the rear of the
machine, as shown in Fig.2, and insert
bolts (10), fit the flat washers (14) and
the nuts (13), tighten securely.
English
and/or those
Take the stabiliser bar with wheels
(11) and position it so that the two red
dots (X) line up, as shown in Fig.2A,
insert bolts (10), fit the flat washers
(14) and the
securely.
3 Mod. H491. Take the screws (8) out
of the main body (A), bring the main
post (6) up to the boss on the main
body, Fig.3, and connect terminals (p)
and (p1). Insert the tip of the cable
sheath into the cable tension control
support (J1), as shown in Fig.4, pull
the sheath (J) up slightly and insert it
into the slot, see Fig.4A, then fit the
main mast onto the boss on the main
body, Fig.5, taking care not to pinch
the cables and make sure that the
tensioning
correctly. Put bolts (8), along with their
washers (7) back in, Fig.6, making
sure that the handlebar is straight and
then tighten securely.
Mod. H-493. Take the screws (8) out
of the main body (A), bring the main
post (6) up to the boss on the main
body, Fig.4B, and connect terminals
(p) and (p1). Put bolts (8), along with
their washers (7) back in, Fig.6,
making sure that the handlebar is
straight and then tighten securely.
4 ATTACHING THE PEDALS.-
The assembly instructions for the
pedals must be followed to the
letter, fitting these incorrectly could
damage the screw thread on the
pedal or the crank.
Right and left refer to the position
that the user adopts when sitting
9
nuts (13),
control (W)
tighten
operates