Troubleshooting - Brandt BFL484YNW Guide D'installation Et D'utilisation

a time when the supply of food stocks
are low and proceed as follows:
-Remove existing food and accessories
baskets, unplug the appliance from the
mains power and leave the doors
open. Ventilate the room thoroughly to
accelerate the thawing process.
Caution! Don't use sharp objects to
remove frost from the refrigerator. Only
after the interior is completely dry
should the appliance be switched back
on and plugged back into the mains
socket.
Door seal cleaning
Take care to keep door seals clean.
Sticky food and drinks can cause seals
to stick to the cabinet and tear when
you open the door. Wash seal with a
mild detergent and warm water. Rinse
and dry it thoroughly after cleaning.
Caution! Only after the door seals are
completely dry should the appliance be
powered on.

Troubleshooting

If you experience a problem with your appliance or are concerned that the
appliance is not functioning correctly, you can carry out some easy checks
before calling for service, please see below. You can carry out some easy
checks according to this section before calling for service.
Warning! Don't try to repair the appliance yourself. If the problem persists
after you have made the checks mentioned below, contact a qualified
electrician, authorized service engineer or the shop where you purchased the
product.
XXXXXXXXXXXXXXXXXXXXXXXXX
33
Replacing the LED light
Warning: The LED light must not be
replaced by the user! If the LED light is
damaged, contact the customer
helpline for assistance. To replace the
LED light, the below steps can be
followed:
1. Unplug your appliance.
2. Remove light cover by pushing up
and out.
3. Hold the LED cover with one hand
and pull it with the other hand while
pressing the connector latch.
4. Replace LED light and snap it
correctly in place.