Remote Control - Panasonic Technics SL-G700 Manuel D'utilisation

Remote control

01 [NWP ]/[CD ]: Standby/on button
• Press to switch the unit from on to standby
mode or vice versa. In standby mode, the
unit is still consuming a small amount of
power.
The input source also switches for each
(switches to the last selected input source
when [NWP ]).
02 [NWP]/[CD]: Select the device to be
operated
• The playing layer switches by pressing [CD]
while the playback stops for Hybrid Super
Audio CD (SACD).
• Press and hold [CD] to switch to "Pure Disc
Playback" mode. ( 18)
03 [>INPUT<]: Switch the input source
04 [DIMMER]: Adjust the brightness of the
power indicator, display, etc.
• Press repeatedly to switch the brightness.
*
2
05 [INFO]: View content information
06 [ ], [ ], [ ], [ ]/[OK]: Selection/OK
07 [RETURN]: Return to the previous
*
display
1
08 [DIRECT]: Turn on/off Direct mode
09 [RE-MASTER]: Turn on/off Re-master
• Press and hold [RE-MASTER] for approx.
2 seconds so that "MQA Decoding : On" is
displayed and the MQA decoding function
will be set to "On". (Press and hold for
approx. 2 seconds again to set the function
to "Off".)
10 [MENU]: Enter menu
11 [SETUP]: Enter setup menu
*
12 Adjust the volume
2
*
13 Mute the sound
2
14 Playback control buttons ( 17)
15 Numeric buttons, etc.
• To enter 2 digits or more
Example:
16: [ 10] > [1] > [6]
124: [ 10] > [ 10] > [1] > [2] > [4]
• [CLEAR]: Clear the entered value.
* 1: Press [NWP]/[CD] first to operate this unit.
(The remote control works only for the
devices supporting system control function
when pressing [AMP].)
* 2: Also works for the devices supporting system
control function.
■
Buttons that work for Technics devices
supporting system control function
The remote control of this unit also works for
Technics devices supporting system control
function (Stereo Integrated Amplifier, etc.). For
information on the operations of the devices,
please also refer to their operating instructions.
[ ] Standby/on button
01
Select the device to be operated
02
Select the input source
03
Measure the output signal when speakers
04
are connected, and correct its output
*
1
*
1
*
1
*
1
(11)
11