Panasonic Technics SL-G700 Manuel D'utilisation page 14

Network settings
Basic
Note
• While the AC mains lead is disconnected, the
LAN cable must be connected or disconnected.
• Use category 7 or above straight LAN cables
(STP) when connecting to peripheral devices.
• Inserting any cable other than a LAN cable in
the LAN port can damage the unit.
• After turning on this unit, it may take some time
until this unit is activated.
• After the network connection is set up,
"Updating" may be displayed and the firmware
for this unit may be updated.
- After the update has finished successfully and
"Success" is displayed, turn this unit off and
then on.
• Even when the Wi-Fi function is set to "On", the
wired LAN function is activated while a LAN
cable being connected. ("
Wireless LAN connection
■
Preparation
Disconnect the AC mains lead.
Disconnect the LAN cable.
Place this unit as close to the wireless router as
possible.
Point up the antenna on the rear of this unit as
shown in the figure.
Connect the AC mains lead to this unit. ( 12)
14
(14)
(Continued)
" is displayed.)
Note
• Do not perform the following:
- Applying too much force to the antenna
- Carrying this unit by holding the antenna
• After turning on this unit, it may take some time
until this unit is activated.
• After the network connection is set up,
"Updating" may be displayed and the firmware
for this unit may be updated.
- After the update has finished successfully and
"Success" is displayed, turn this unit off and
then on.
• The setting will be cancelled after the set time
limit. In that case, try the setting again.
• " " blinks while the network setting is not
complete, and blinking stops after the Wi-Fi
setting is complete.
• While "
" is blinking, the network setting
from "Google Home" may be available. Start
the "Google Home" app and follow the on-
screen instructions.
• To cancel this setting in the middle, press [
turn the unit to standby mode.
Network setting for the first time using
the "Google Home" app
1 Press [NWP ]/[CD
unit on.
• "Wi-Fi Setup" is displayed.
2 Press [ ], [ ] to select "On" and press
[OK] on the "Wi-Fi" screen.
(It enables the Wi-Fi function)
3 Start the "Google Home" app and
follow the on-screen instructions.
Note
• This unit will be displayed as "Technics-
SL-G700- " if the device name is not set.
****
(" **** " stands for characters unique to each
set.)
• You can check your network information (SSID,
MAC address and IP address) from the "Google
Home" app or "Technics Audio Center" app.
• Some items on the "Google Home" app are
irrelevant to this unit.
• To cancel this setting in the middle, press [
turn the unit to standby mode.
• When this unit is switched to standby mode and
turned on before the Wi-Fi setting is complete,
"Wi-Fi Setup" is displayed. Perform the Wi-Fi
setting or select "Off".
• For other connection methods (15)
] or
] to turn this
] or