Table des Matières
Publicité
Area 1 See figure 8
Superficie 1. Vea la Figura 8
Zone 1
Voir figure 8
Vacuum only,
Para eliminar
after cleaning
la mayor
each area for
cantidad de
maximum
agua posible
water removal
sólo realice la
aspiración
después de
limpiar cada
superficie
Figure 8A
Figure 8B
Page 22
MACHINE OPERATING INSTRUCTIONS
How to Clean an Area of Carpet See Figure 8A
To clean an area of carpet, follow this procedure:
1. Start the pump for the solution and the motor for the
2. Begin at the right-hand corner of the carpet.
3. Hold the floor tool at the angle that gives the best
4. Apply pressure to the lever for solution release. Pull
Aspiration
seulement,
5. To clean the edge of a room, move the tool along the
après nettoyage
de chaque zone
6. To clean a small area of carpet, clean the carpet in
pour une
élimination
maximum de
7. To remove more liquid from the carpet, make passes
l'eau
How To Clean A Larger Area Of Carpet See Fig. 8B
To clean a larger area of carpet, follow this procedure:
1. Begin at the right-hand corner of the carpet.
2. Make a pass halfway along the edge of the carpet.
3. Move to the edge of the carpet. Make another pass
4. As you make more passes, repeat one inch of the
5. Make more passes until half of the carpet is cleaned.
6. Move to the right-hand corner of the part of the carpet
7. Make a pass halfway along the edge of the carpet.
8. As you make passes, repeat one inch of the area
9. Make more passes until all of the room is cleaned.
CLARKE TECHNOLOGY
WARNING:
Do not use water that is hotter
than 120°F (48°C).
vacuum on the extractor.
vacuum seal between the tool and the carpet.
the tool toward you at a slow, steady speed. To
remove as much solution as possible, release the
lever before you stop moving backward. Push tool
away over the same area while moving tool to next
position. (Repeat process)
baseboard until the edge of all the carpet is cleaned.
sections three feet square. As you make more
passes, repeat one inch of the area already cleaned.
over the area already cleaned, but do not apply
pressure to the lever for the solution.
Pull the tool backward at a steady speed.
next to your first pass.
area already cleaned. If you use a power brush tool,
repeat one inch of the area already cleaned by the
brush. Make each pass four inches different in length
to prevent making a line in the center of the carpet.
To remove more liquid from the carpet, make passes
over the area already cleaned, but do not apply
pressure to the lever for the solution.
not yet cleaned.
already cleaned.
CAUTION:
ALTO U.S. (CLARKE TECHNOLOGY) will
not be held liable for damage to the car-
pet, or poor results because of the
operator's lack of ability.
B
®
EXT
-100, 100H, 300HV 230V Operator's Manual
Publicité
Table des Matières
