Maintenance/Cleaning - Vortice VORT SUPER DRY Notice D'emploi

ENGLISH

Maintenance/cleaning

WARNING
• Before you clean the unit turn off the power switch.
• Do not splatter water on the unit.
CAUTION
• Wear gloves when cleaning.
• The antibacterial coating is effective when the bacteria exposed the coated surfaces.
• The antibacterial coating becomes not effective when the surfaces get very dirty.
Cleaning the unit body
before it gets obviously dirty:
• Clean the unit with a soft cloth. If the unit get very dirty, clean with a soft cloth dampened with neutral agents, then clean
with a dry soft cloth.
• Remove the dirt from sensor. (to prevent malfunction).
• Only use the neutral cleaning agents.
• Do not use thinner, acidic or alkaline toilet cleaners, or nylon brush. Only use the alcohol to clean the hand drying area.
(Do not use the alcohol anywhere else) ※Alcohol here means the alcohol used for disinfection (Concentration below
83%).
• If the chemical cloths used please read their instructions first.
• Disinfecting agents will damage your unit.
Draining and cleaning the drain tank
(fig.10)
before it fills up (at least once a week):
The water blown off the hands in called" drain water
• Empty the drain water at any moment, in order to prevent
Accumulated water from exceeding the full level
• It will start smelling if the accumulated water remains in
the tank for too long time.
Pull the drain tank out in the Horizontal direction.
This ensures the drain water does not splatter out.
(Fig.11)
Open the cover and empty the water
• Pull the cover up with your fingers in
the direction of the arrow on topof
the cover, and then remove the cover
completely.
11 11
cover
20
(Fig.12)
• Wash out the interior of the drain
tank
• Close the water tank cover, and Re-
attach it to the unit as original.
12 12
drain tank
10 10
(Fig.13)
• Confirm the two locations are firmly
inserted.
13 13
drain tank
cover
drain tank