Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
Installation
N.B.
If the unit is equipped with a plug ignore the instructions describing the electrical connections.
• Use a single-phase alternating rated voltage supply, (Do not used with a power supply exceeding rated voltage ±10% ).
• Use a power cord which is between 2 mm
be used).
(A drop in voltage is possible if the power cord exceeds
11m in length, so we recommend using a 2.5mm2
cord.).
Wire the unit
(Fig.19)
Embed the switch box in the installation location
(1 switchbox no cover)and wire the power cord
(with the green and yellow combined is ground line).
• If no switchbox is used, the power cord will be pushed out,
and prevent the unit from being installed firmly against the
wall.
Attach the installation panel to the wall using the 6
installation screws.
(Fig.20)
• If the wall is concrete, use commercially available metal
screw plugs(curl plugs, etc.)
• If the wall is not concrete, reinforce it before installation.
Remove the drain tank
(Fig.21)
21
21
drain tank
unit
2
2
and 2.5 mm
Remove the front panel
• Remove the two screws.
• Remove the terminal box cover screw.
(Fig.22)
22
22
front panel
installation
screw
front panel
unit
thick, (Cords other than 2mm
19
19
20
20
Installation screws
viti di montaggio
pannello di
Installation
panel
installazione
chuckhole
2
2
- 2.5 mm
single-core cords cannot
Power cords
cavi di alimentazione
(with ground line)
(con linea di terra)
Switchbox
scatola fusibili
Remove the terminal box cover
• Remove the terminal box cover screw
and pull the cover other towards you.
(Fig.23)
23
23
terminal box
lock clutch hole
terminal box
cover
l
ock
clutch
terminal box screw
Installation hole
dettaglio dei fori
details
di montaggio
unit
25
Publicité
Table des Matières
