Vortice VORT SUPER DRY Notice D'emploi page 26

ENGLISH
(Fig.24)
Pull the separate line power cord into the unit and
secure inside
This machine has been made with power cord, if you want
to change, please according to the following steps.
• Pull the power cord through the power cord hole on the
rear of the unit, attach the rear side to the 3 hooks on the
installation panel, and secure with the installation screws
(temporarily fixed on the unit side) while pushing the unit
against the wall lightly).
• The installation screws for the unit will not tighten
completely if the hooks at the bottom of the installation
panel are not in the place. Ensure the lower hooks are
completely hooked onto the rear of the unit.
Note
Ensure the unit is hooked on the installation Panel, tightened the safety screws (at the low right). Otherwise, this may cause
the unit to drop and be in the danger of theft.
(Fig.25)
Wire the terminal box (there is no polarity)
• Strip the wire shealts shown in fig 25.
• Loosen the screws on the terminal box and connect the
power cord to the terminal box
• Remove the protective seal attached to the terminal box
before connecting the ground wire
• Tighten the screws on the terminal box and pull the power
cord to make sure it is secured firmly
• Bind the power cord using the clip to the right of the
terminal box and fix it to its original location.
(Fig.26)
Attach the terminal bos cover.
• Place the terminal box tabs into the hoes and return to
cover to its original position, securing it with the screw.
• Make sure the power cord and other wires are not piched
• The front panel cannot be attached if there are any wires
in front of the terminal box cover. Moves the wires to the
right of the terminal box cover
26
24 24
presa di
Power socket
alimentazione
cavo elettrico
Power cord
Safety vite di
screw
sicurezza
25 25
unscrew here
to change fuse
earth wire
power cord
screw
26 26
gancio
Upper hook superiore
power cord power cord
Power cord
Installation
pannello pannello
panel
installazione installazione
Safety vite di vite di
screw sicurezza sicurezza
terminal box
power cord
power cord
retainer