Publicité
Les langues disponibles
Les langues disponibles
Owner's manual
CONNECTION
Please make sure that the amplifier is powered-off before connecting the speaker
system.
Banana plugs
Use banana plug cables to connect the system.
Speaker cables
Use the speaker cable to connect the speakers with amplifier (as shown on the
illustration). please connect the left channel of the speaker to "L" terminal of the
amplifier, and the right channel of the speaker should be connected to "R" terminal
of the amplifier. Attention to the mark of positive pole and negative pole (with
corresponding "+" and "-"). The inversion of positive pole and negative pole results
in sound distortion and may lead to damage.
1. Strip of insulation and tighten the wires by hand
in order to settle its protruded places and avoid
short circuit.
2. Release the copper post in counter clockwise
direction, and put the wire end
into the hole.
3. Screw
the
copper
clockwise direction. Make sure
the connection is firmly executed.
Attention: the two pieces of the metal
wire of the cable never be touched
by each other.
post
in
7
Publicité
