Télécharger Imprimer la page

Krüger & Matz KM0502C Mode D'emploi page 6

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 9
SAFETY INSTRUCTIONS
Read the instruction manual carefully before first use and keep it for future
reference.
1. Make sure to place this product on flat, dry and stable surface.
2. place the device in a properly ventilated place.
3. protect this product from moisture, humidity, water and any other liquid. Avoid
using/storing it in extreme temperatures. Do not expose it to direct sunlight
and sources of heat.
4. keep the device beyond children's reach.
5. product suitable for indoor use only.
6. Never use this device if the speaker cord is damaged.
7. Speaker cord should be routed so that it is not likely to be pinched by items
placed upon or against them.
8. Do not attempt to repair or dismantle this device yourself. In case of damage,
contact with an authorized service point for check-up/repair.
9. Clean this device with soft, slightly damp cloth. Do not use any abrasives or
chemical agents to clean this product.
10. Never exceed the input power beyond the maximum input power of the
speaker system.
SPEAKER INSTALLATION
Except the speaker units' quality, the acoustic quality of the speaker system
also depends on factors like the size and mode of rooms, speaker installation
means and so on. Thus, please pay attention to the following points during
installation:
• When the speaker is placed directly on the floor, the subwoofer effect will be too
obvious. Then one cement board or other hard support plate should be needed
to be placed on the floor.
• Attention: when the speaker and the sound source or the amplifier are placed on
the same support object, the speaker may blare screams.
• If there are walls or glass door behind or in front of the speaker system in the
short distance, please note that heavy curtains should be needed on the wall or
the glass door in order to avoid unnecessary resonance and reverberation effect.
• This model speaker system is with antimagnetic design. For most CRT television
receivers, it can stand near the speaker without bad TV image result. But for some
television, maybe the speaker is too close to it and results in image color damage.
When this situation happens, please move the speaker a little away from the
television.
6
Owner's manual

Publicité

loading

Ce manuel est également adapté pour:

Km0504cKm0506c