Blowing Feature - RIDGID RV2400HF0 Mode D'emploi

SP6775-2 RV2400HF ESF RIDGID
Operation (continued)

Blowing Feature

Your Vac features a blowing port. It can
blow sawdust and other debris. Follow the
steps below to use your Vac as a blower.
!
WARNING: Always wear safety
eyewear complying with ANSI Z87.1
(or in Canada, CSA Z94.3) before
using as a blower.
!
WARNING: To reduce the risk of
injury to bystanders, keep them
clear of blowing debris.
!
CAUTION: Wear an appropriate
respirator/dust mask if blowing
creates dust which might be
inhaled.
!
CAUTION: To reduce the risk of
hearing damage, wear ear protectors
when using the Vac/Blower for
extended time or in a noisy area.
6/27/12 12:00 PM
1. Locate blowing port of your Vac.
2. Insert the locking end of the tug-along
hose into the blowing port of the Vac.
The hose should snap into place.
3. (Optional) Attach extension wand to
opposite end of hose.
4. Turn Vac on and you are ready to use
your Vac as a blower.
Swivel
End of
Hose
13
Page 13
Tug-A-Long
Hose
Extension Wand
(Optional)