Operation - RIDGID RV2400HF0 Mode D'emploi

SP6775-2 RV2400HF ESF RIDGID

Operation

!
WARNING: To reduce the risk of fire, explosion, or damage to Vac:
• Do not leave Vac running while unattended - you may fail to notice important
signs indicating abnormal operation such as loss of suction, debris/liquid
exiting the exhaust, or abnormal motor noises. Immediately stop using Vac
if you notice these signs.
• Do not leave Vac plugged in when not in use.
• Do not continue running when float has cut off suction.
• Sparks inside the motor can ignite airborne flammables. Do not operate Vac
near flammable liquids or in areas with flammable gases, vapors, or
explosive/airborne dust. Flammable liquids, gases, and vapors include:
lighter fluid, solvent-type cleaners, oil-based paints, gasoline, alcohol, and
aerosol sprays. Explosive dusts include: coal, magnesium, aluminum,
grain, and gun powder.
• Do not vacuum up explosive dusts, flammable liquids, or hot ashes.
!
• Do not expose to rain or allow liquid to enter motor compartment. Store
indoors.
• Do not handle plug, switch, or Vac with wet hands.
• Unplug Vac before servicing. If your Vac is not working as it should, has
missing parts, has been dropped, damaged, left outdoors, or dropped into
water, return it to an independent service center or call customer service.
• When using an extension cord, use only outdoor-rated cords that are in
good condition. Do not allow the connection to come into contact with
liquid.
After you plug the power cord into the
outlet, turn the unit on by pushing the
switch from position "O" to position "l".
The symbols used on the switch actuator
are international "On & Off" symbols:
= OFF
Familiarize yourself with the accessories
included with the Vac. Each accessory may
be used in various ways for vacuuming and
blowing debris. Here is a list of some of the
accessories and their uses.
Diffuser - Use to disperse the exhaust air
stream while reducing noise. Insert into
the blowing port.
Extension Wands - These wands can be
connected together and provides
additional length for more reach.
6/27/12
WARNING: To reduce the risk of electric shock or injury:
= ON
12:00 PM Page 11
Turbo Nozzle - This air driven beater bar
tool is used for large area clean-up on
carpeted surfaces.
Hose - Provides transfer of vacuum or
blowing capability to work site. Provides
the means of attaching extension wands
and nozzles.
Utility Nozzle - General purpose nozzle
for most vacuuming applications.
Wet Nozzle - Used for wet pickup on
smooth surfaces to pick up liquid and dry
the surface in one stroke.
14" Floor Brush - Used for large area
clean-ups on smooth surfaces.
Dusting Brush - Can be used with a
1-1/4" or a 2-1/2" hose with included
adapter.
2.5" to 1.25" Adapter - Allows
accessories to adapt to a 2-1/2" hose.
11