Description Of Your Appliance; Or Ice Box Compartment - Brandt BFT512S Guide D'installation Et D'utilisation

1 / INSTALLATION
ALLATION

DESCRIPTION OF YOUR APPLIANCE

(depending on the model)
E
E
C
C
A Thermostat
B Door shelves
C Vegetable compartment
Bottle shelf
D
Freezer or ice box
E
The appliance consists of 2 compartments: the lower compartment
for refrigerating and preserving fresh food and an upper
compartment for preserving frozen food for a maximum of 2 weeks
or an upper compartment for preserving frozen
food, freezing fresh food and producing ice cubes.
A
A
B B
D
D
. .
compartment
REVERSING THE DIRECTION THE DOORS
OPEN
You can alter the direction in which the doors open if you wish:
The appliance must always be disconnected from the power
supply when changing the direction the doors open.
• Gently tilt the appliance backwards and wedge it in this position.
• Remove the pin from the lower hinge and then remove the door.
Remove the lower hinge and fit it on the opposite side.
• Unscrew the upper hinge and fit this on the opposite side.
• Take the plastic guide off the hinge pin for the upper hinge and
press it into the opposite hole after removing the hole cover, which
is subsequently placed over the hole you have just created.
• Slide the door onto the pin for the upper hinge and close it.
• Insert the pin for the lower hinge and screw it down tightly.
• If your appliance is fitted with a vertical handle, ensure that you
move it over to the opposite side.
You can also change the direction the ice box door opens:
• Partially open the door of the
• Unscrew the door's lower hinge pin and remove the door.
• Unscrew the door catch and fit it on the other side.
• Move the guide for the door's upper hinge pin to the opposite
hole.
• Fit the door in the guide and hold it while screwing in the lower
hinge pin.
F
ITTING THE DOOR HANDLES
(depending on the model)
The handles are located inside the refrigerator. Fit the handles on
the doors, positioning them opposite the respective holes and fas-
ten them with the screws provided as shown in the diagram below.
Once the handles are in place, insert the screw covers supplied in
the spaces provided for this purpose
. .
REMOVING THE REMOVABLE TOP
(depending on the model)
To install your appliance under a worktop, you may need to remove
its top.
The appliance must always be disconnected when you proceed
to remove the removable top.
• Remove the two screws at the back of the top.
• Free the top by lifting it at the back and sliding it gently forwards.
04
. .
ice box compartment.
EN